DEHR33D102KA3B View Datasheet(PDF) - Unspecified

Part Name

Description

View to exact match

DEHR33D102KA3B

Lead Type Disc Ceramic Capacitors (Safety Standard Certified) Resin Molding SMD Type Ceramic Capacitors (Safety Standard Certified)

Unspecified 

!Note • Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.

• This catalog has only typical specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.

Type EA !Caution

1

Continued from the preceding page.

(2) Voltage Applied Method

When the withstanding voltage is applied, the capacitor's

lead or terminal should be firmly connected to the output

of the withstanding voltage test equipment, and then the

voltage should be raised from near zero to the test

voltage.

If the test voltage without the raise from near zero

voltage would be applied directly to capacitor, test

voltage should be applied with the zero cross.* At the

end of the test time, the test voltage should be reduced

to near zero, and then capacitor's lead or terminal should

be taken off the output of the withstanding voltage test

equipment.

If the test voltage without the raise from near zero

voltage would be applied directly to capacitor, the surge

voltage may rise, and therefore, a defect may be caused.

*ZERO CROSS is the point where voltage sine wave

passes 0V. See the figure at right.

4. Fail-Safe

When the capacitor is broken, failure may result in a

short circuit. Be sure to provide an appropriate fail-safe

function like a fuse on your product if failure could result

in an electric shock, fire or fuming.

FAILURE TO FOLLOW THE ABOVE CAUTIONS MAY

RESULT, WORST CASE, IN A SHORT CIRCUIT

AND CAUSE FUMING OR PARTIAL DISPERSION

WHEN THE PRODUCT IS USED.

Voltage sine wave

0V

zero cross

C85E.pdf

Sep.14,2018

12

Share Link: