Table 4. Dynamic Electrical Characteristics (continued)
Characteristics noted under conditions 6.0 V VPWR 20 V, 3.0 V VDD 5.5 V, - 40 C TA 125 C, GND = 0 V unless
otherwise noted. Typical values noted reflect the approximate parameter means at TA = 25 °C under nominal conditions unless
otherwise noted.
Characteristic
Symbol
Min
Typ
Max
Unit
POWER OUTPUT TIMING HS0 TO HS1 (continued)
Fault Detection Blanking Time(28)
Output Shutdown Delay Time(29)
CSNS Valid Time(30)
Watchdog Time-out(31)
ON OpenLoad Fault Cyclic Detection Time with LED
tFAULT
1.0
5.0
20
s
tDETECT
–
7.0
30
s
t CNSVAL
–
70
100
s
t WDTO
217
310
400
ms
TOLD(LED)
105
150
195
ms
Notes
28. Time necessary to report the fault to FSB pin.
29. Time necessary to switch-off the output in case of OT or OC or SC or UV fault detection (from negative edge of FSB pin to HS voltage =
50% of VPWR
30. Time necessary for CSNS to be within ±5% of the targeted value (from HS voltage = 50% of VPWR to ±5% of the targeted CSNS value).
31. For FSI open, the Watchdog time-out delay measured from the rising edge of RSTB, to HS[0,1] output state depend on the corresponding
input command.
Analog Integrated Circuit Device Data
Freescale Semiconductor
07XSC200
13