AT27BV1024 View Datasheet(PDF) - Atmel Corporation

Part Name

Description

View to exact match

AT27BV1024

1-Megabit (64K x 16) Unregulated Battery-Voltage High-Speed OTP EPROM

Atmel Corporation 

AT27BV1024

3. System Considerations

Switching between active and standby conditions via the Chip Enable pin may produce transient

voltage excursions. Unless accommodated by the system design, these transients may exceed

datasheet limits, resulting in device non-conformance. At a minimum, a 0.1 µF high frequency,

low inherent inductance, ceramic capacitor should be utilized for each device. This capacitor

should be connected between the VCC and Ground terminals of the device, as close to the

device as possible. Additionally, to stabilize the supply voltage level on printed circuit boards

with large EPROM arrays, a 4.7 µF bulk electrolytic capacitor should be utilized, again con-

nected between the VCC and Ground terminals. This capacitor should be positioned as close as

possible to the point where the power supply is connected to the array.

4. Block Diagram

5. Absolute Maximum Ratings*

Temperature Under Bias............................... -55° C to +125° C

Storage Temperature .................................... -65° C to +150° C

Voltage on Any Pin with

Respect to Ground .........................................-2.0V to +7.0V(1)

Voltage on A9 with

Respect to Ground ......................................-2.0V to +14.0V(1)

*NOTICE:

Stresses beyond those listed under “Absolute

Maximum Ratings” may cause permanent dam-

age to the device. This is a stress rating only and

functional operation of the device at these or any

other conditions beyond those indicated in the

operational sections of this specification is not

implied. Exposure to absolute maximum rating

conditions for extended periods may affect

device reliability

VPP Supply Voltage with

Respect to Ground .......................................-2.0V to +14.0V(1)

Note: 1. Minimum voltage is -0.6V DC which may undershoot to -2.0V for pulses of less than 20 ns. Maximum output pin voltage is

VCC + 0.75V DC which may overshoot to +7.0V for pulses of less than 20 ns.

3

0631E–EPROM–12/07

Share Link: