Description
The STM8S007C8 value line 8-bit microcontrollers offer 64 Kbytes Flash program memory. They are referred to as high-density devices in the STM8S microcontroller family reference manual (RM0016).
The STM8S007C8 value line devices provide the following benefits: reduced system cost, performance, robustness, short development cycles, and product longevity.

FEATUREs
• Core
   – Max fCPU: up to 24 MHz, 0 wait states @ fCPU ≤ 16 MHz
   – Advanced STM8 core with Harvard architecture and 3-stage pipeline
   – Extended instruction set
   – Max 20 MIPS @ 24 MHz
• Memories
   – Program: 64 Kbytes Flash; data retention 20 years at 55 °C after 100 cycles
   – Data: 128 bytes true data EEPROM; endurance 100 kcycles
   – RAM: 6 Kbytes
• Clock, reset and supply management
   – 2.95 to 5.5 V operating voltage
   – Low power crystal resonator oscillator
   – External clock input
   – Internal, user-trimmable 16 MHz RC
   – Internal low power 128 kHz RC
   – Clock security system with clock monitor
   – Wait, active-halt, & halt low power modes
   – Peripheral clocks switched off individually
   – Permanently active, low consumption power-on and power-down reset
• Interrupt management
   – Nested interrupt controller with 32 interrupts
   – Up to 37 external interrupts on 6 vectors
• Timers
   – 2x 16-bit general purpose timers, with 2+3 CAPCOM channels (IC, OC or PWM)
   – Advanced control timer: 16-bit, 4 CAPCOM channels, 3 complementary outputs, deadtime insertion and flexible synchronization
   – 8-bit basic timer with 8-bit prescaler
   – Auto wakeup timer
   – Window watchdog, independent watchdog
• Communications interfaces
   – UART with clock output for synchronous operation - LIN master mode
   – UART with LIN 2.1 compliant, master/slave modes and automatic resynchronization
   – SPI interface up to 10 Mbit/s
   – I2C interface up to 400 Kbit/s
• 10-bit ADC with up to 16 channels
• I/Os
   – 38 I/Os including 16 high sink outputs
   – Highly robust I/O design, immune against current injection
   – Development support
   – Single wire interface module (SWIM) and debug module (DM)