datasheetbank_Logo
数据手册搜索引擎和 Datasheet免费下载 PDF

ZXLD1356Q 查看數據表(PDF) - Diodes Incorporated.

零件编号
产品描述 (功能)
生产厂家
ZXLD1356Q
Diodes
Diodes Incorporated. 
ZXLD1356Q Datasheet PDF : 28 Pages
First Prev 21 22 23 24 25 26 27 28
ZXLD1356Q
Q
Application Information (Cont.)
Dimming Output Current Using PWM
Low Frequency PWM Mode
When the ADJ pin is driven with a low frequency PWM signal (e.g. 100Hz), with a high level voltage VADJ and a low level of zero, the output of
the internal low pass filter will swing between 0V and VADJ, causing the input to the shutdown circuit to fall below its turn-off threshold (200mV
nom) when the ADJ pin is low. This will cause the output current to be switched on and off at the PWM frequency, resulting in an average output
current IOUTavg proportional to the PWM duty cycle. (See Figure 4 - Low frequency PWM Operating Waveforms).
Figure 4 Low Frequency PWM Operating Waveforms
The average value of output current in this mode is given by:
IOUT avg
0.2DPWM
RS
for DPWM > 0.001
This mode is preferable if optimum LED 'whiteness' is required. It will also provide the widest possible dimming range (approx. 1000:1) and
higher efficiency at the expense of greater output ripple.
Open and Shorted LED Protection
The ZXLD1356Q has by default open LED protection. If the LEDs should become open circuit the ZXLD1356Q will stop oscillating;
The SET pin will rise to VIN and the SW pin will then fall to GND.
No excessive voltages will be seen by the ZXLD1356Q.
If the LEDs should become shorted together the ZXLD1356Q will continue to switch, however, the duty cycle at which it will operate will
change dramatically and the switching frequency will most likely decrease.
The on-time of the internal power MOSFET switch will be significantly reduced because almost all of the input voltage is now
developed across the inductor.
The off-time will be significantly increased because the reverse voltage across the inductor is now just the Schottky diode voltage
(see Figure 20) causing a much slower decay in inductor current.
During LED-shorted condition the inductor current will remain within its controlled levels and no excessive heat will be generated
within the ZXLD1356Q.
ZXLD1356Q
Document number: DS37077 Rev. 2 - 2
24 of 28
www.diodes.com
October 2015
© Diodes Incorporated

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]