XS2F-D422-J80-R 查看數據表（PDF） - Unspecified

零件编号

产品描述 (功能)

生产厂家

XS2F-D422-J80-R

Round Water-resistant Connectors (M12)

Unspecified 

XS2

Insertion

Pin Block

Pin Clamp

Key groove Key groove

Key

XS2C use XS2G use

• Bend the cable as shown below, attached the enclosed

insulation cap, and then strip the other cores.

6±0.5

• Tentatively insert the pins to the pin block holes so that the

key on the pin block will coincide with the key groove on the

pin clamp. Then insert the cable along with the pin clamp.

Screw-on Connectors

Cable End Processing

• Four-pole Connectors

8

12

Insulation cap

• Connect the cores to pins 1 to 4.

Connecting Shielded Cables to Five-pole Connectors

• Place the insulation tub on the drain line of the shield and

connect ti to the terminal.

• Tighten the screw and then check visually to see if there is

insulation between the cores.

Drain line

Insulation tube

12±0.5

• Loosen the screws on pins 1 to 4 and insert the cores

according to the pin numbers.

• Connect the cores to pins 1 to 4.

*When tightening the screws, use the dedicated XW4Z-00B

Screwdriver that matches with the screw-slot dimensions.

• Use the special Screwdriver (XW4Z-00B) * and tighten the

screws securely so that the cores do not pull out (tightening

torque: 0.15 to 0.2 N·m).

• Five-pole Connectors

• Strip the cable sheath for a total of 15 mm and strip the core

covering for 8 mm for the core to connect to pin 5.

8

12

Conductors for

pins 1 to 4

87

Conductors for

pin 5

• Connect the core to pin 5 (in the center) first.

• Insert the core from the side of the hold with the tab and

tighten the screw securely (tightening torque: 0.15 to

0.2 N·m), and then cut off the excess wire with wire cutters.

Screw

Special

Screwdriver

Screw

Special

Screwdriver

Tab

XW4Z-00B

Screwdriver

(4) Inserting Pin Block

Pin Block

(Soldering Model)

Cover

(Straight Model)

Lock spring

O-ring

Polarity key

Positioning key

(triangle mark) Triangle mark

(Crimping Model)

(L-shaped Model)

• Mount the cover to the pin block so that the triangle mark on

the pin block will coincide with the triangle mark on the

cover.

• If the cover is used for an L-shaped model, the relationship

between the position of the polarity key on the engaged side

and cable connection direction will be determined by the

direction in which the positioning key is inserted into the

cover, which can be rotated by 90°.

• Fully insert the positioning key until the positioning key is

hidden by the casing.

25

Share Link: