FL7930C(2013) 查看數據表（PDF） - Fairchild Semiconductor

零件编号

产品描述 (功能)

生产厂家

FL7930C
(Rev.:2013)

Single-Stage Flyback and Boundary-Mode PFC Controller for Lighting

Fairchild Semiconductor 

PCB Layout Guide

PFC block normally handles high switching current and

the voltage low energy signal path can be affected by

the high energy path. Cautious PCB layout is mandatory

for stable operation.

1. The gate drive path should be as short as possible.

The closed-loop that starts from the gate driver,

MOSFET gate, and MOSFET source to ground of

PFC controller should be as close as possible. This

is also crossing point between power ground and

signal ground. Power ground path from the bridge

diode to the output bulk capacitor should be short

and wide. The sharing position between power

ground and signal ground should be only at one

position to avoid ground loop noise. Signal path of

the PFC controller should be short and wide for

external components to contact.

2. The PFC output voltage sensing resistor is normally

high to reduce current consumption. This path can

be affected by external noise. To reduce noise

potential at the INV pin, a shorter path for output

sensing is recommended. If a shorter path is not

possible, place some dividing resistors between

PFC output and the INV pin — closer to the INV pin

is better. Relative high voltage close to the INV pin

can be helpful.

3. The ZCD path is recommended close to auxiliary

winding from boost inductor and to the ZCD pin. If

that is difficult, place a small capacitor (below

50 pF) to reduce noise.

4. The switching current sense path should not share

with another path to avoid interference. Some

additional components may be needed to reduce

the noise level applied to the CS pin.

5. A stabilizing capacitor for VCC is recommended as

close as possible to the VCC and ground pins. If it is

difficult, place the SMD capacitor as close to the

corresponding pins as possible.

Figure 44. Recommended PCB Layout

© 2011 Fairchild Semiconductor Corporation

FL7930C • Rev. 1.0.2

17

www.fairchildsemi.com

Share Link: