SC4213H 查看數據表（PDF） - Semtech Corporation

零件编号

产品描述 (功能)

生产厂家

SC4213H

Very Low Input /Very Low Dropout 0.5 Amp Regulator With Enable

Semtech Corporation 

SC4213H

Pin Descriptions

Pin #

Pin Name

2

EN

3

6

7

8

1, 4, 5

VIN

VO

FB

GND

NC

THERMAL PAD

Pin Function

Enable Input. Pulling this pin below 0.4V turns the regulator off, reducing the quiescent current to

a fraction of its operating value. The device will be enabled if this pin is left open. Connect to VIN if

not being used.

Input voltage. For regulation at full load, the input to this pin must be between (VO+ 0.5V) and

6.0V. Minimum VIN = 1.4V. A large bulk capacitance should be placed close to this pin to ensure

that the input supply does not sag below 1.4V. Also a minimum of 4.7µF ceramic capacitor should

be placed directly at this pin.

The pin is the power output of the device. A minimum of 10uF capacitor should be placed directly

at this pin.

Tied to external feedback resistors to program the output voltage. The output voltage will be

determined by the resistor ratio (See Application Circuits on page 1)

Reference ground. The GND pin and the exposed die pad must be connected together at the IC

pin.

No Connection.

Pad for heatsinking purposes. Connect to ground plane using multiple vias.

Block Diagram

© 2010 Semtech Corporation



Share Link: