PM6680 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

生产厂家

PM6680

No Rsense dual step-down controller with adjustable voltages for notebook system power

STMicroelectronics 

Pin settings

PM6680

Table 4. Pin functions (continued)

N°

Pin

Function

16

SGND2

Signal ground for analog circuitry. It must be connected to the signal ground

plan of the power supply.

Internal 5 V regulator bypass connection.

• If V5SW is connected to OUT5 (or to an external 5 V supply) and V5SW is

17

V5SW

greater than 4.9 V, the LDO5 regulator shuts down and the LDO5 pin is

directly connected to OUT5 through a 3 Ω (max) switch.

If V5SW is connected to GND, the LDO5 linear regulator is always on.

18

LDO5

5 V internal regulator output. It can provide up to 100mA peak current.

LDO5 pin supplies embedded low side gate drivers and an external load.

19

VIN

Device supply voltage input and battery voltage sense. A bypass filter (4 Ω

and 4.7 µF) between the battery and this pin is recommended.

Positive current sense input for the switching section 1. This pin must be

20

CSENSE1

connected through a resistor to the drain of the synchronous rectifier

(RDSON sensing) to obtain a positive current limit threshold for the power

supply controller.

21

PHASE1

Switch node connection and return path for the high side driver for the

section 1.It is also used as negative current sense input.

22

HGATE1

High-side gate driver output for section 1. This is the floating gate driver

output.

23

BOOT1

Bootstrap capacitor connection for the switching section 1. It supplies the

high-side gate driver.

Pulse skipping mode control input.

• If the pin is connected to LDO5 the PWM mode is enabled.

24

SKIP

• If the pin is connected to GND, the pulse skip mode is enabled.

• If the pin is connected to VREF the pulse skip mode is enabled but the

switching frequency is kept higher than 33 kHz (No-audible pulse skip

mode).

Enable input for the switching section 1.

• The section 1 is enabled applying a voltage greater than 2.4 V to this pin.

25

EN1

• The section 1 is disabled applying a voltage lower than 0.8 V.

When the section is disabled the High Side gate driver goes low and Low

Side gate driver goes high.

Power Good output signal for the section 1. This pin is an open drain output

26

PGOOD1 and when the output of the switching section 1 is out of +/- 10 % of its

nominal value.It is pulled down.

Power Good output signal for the section 2. This pin is an open drain output

27

PGOOD2 and when the output of the switching section 2 is out of +/- 10 % of its

nominal value.It is pulled down.

Feedback input for the switching section 1. This pin is connected to a

28

FB1

resistive voltage-divider from OUT1 to PGND to adjust the output voltage

from 0.9 V to 5.5 V.

10/49

Share Link: