EL1507
Absolute Maximum Ratings (TA = +25°C)
VS+ to VS- Supply Voltage. . . . . . . . . . . . . . . . . . . . . . . . . . . . 26.4V
VS+ Voltage to Ground . . . . . . . . . . . . . . . . . . . . . . -0.3V to +26.4V
VS- Voltage to Ground . . . . . . . . . . . . . . . . . . . . . . . . -26.4V to 0.3V
Input C0/C1 to Ground . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7V
VIN+ Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . VS- to VS+
Current Into Any Input . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8mA
Continuous Output Current . . . . . . . . . . . . . . . . . . . . . . . . . . . 75mA
Operating Temperature Range . . . . . . . . . . . . . . . . .-40°C to +85°C
Storage Temperature Range . . . . . . . . . . . . . . . . . .-60°C to +150°C
Operating Junction Temperature . . . . . . . . . . . . . . .-40°C to +150°C
Power Dissipation . . . . . .See Power Supplies & Dissipation section
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
IMPORTANT NOTE: All parameters having Min/Max specifications are guaranteed. Typical values are for information purposes only. Unless otherwise noted, all tests
are at the specified temperature and are pulsed tests, therefore: TJ = TC = TA
Electrical Specifications VS = ±12V, RF= 1.5kΩ, RL= 75Ω to GND, TA = +25°C. unless otherwise specified.
PARAMETER
DESCRIPTION
CONDITIONS
MIN
TYP
AC PERFORMANCE
BW
-3dB Bandwidth
HD
Total Harmonic Distortion
dG
Differential Gain
dθ
Differential Phase
SR
Slew Rate
DC PERFORMANCE
AV = +4
f = 1MHz, VO = 16VP-P, RL = 50Ω
AV = +2, RL = 37.5Ω
AV = +2, RL = 37.5Ω
VOUT from -4.5V to +4.5V
70
-75
0.17
0.1
350
500
VOS
Offset Voltage
ΔVOS
VOS Mismatch
ROL
Transimpedance
INPUT CHARACTERISTICS
VOUT from -4.5V to +4.5V
-17
-10
1
2
IB+
Non-Inverting Input Bias Current
IB-
Inverting Input Bias Current
ΔIB-
IB- Mismatch
eN
Input Noise Voltage
iN+
+Input Noise Current
iN-
-Input Noise Current
VIH
Input High Voltage
VIL
Input Low Voltage
IIH1
Input High Current for C1
IIH0
Input High Current for C0
IIL
Input Low Current for C1 or C0
OUTPUT CHARACTERISTICS
C0 & C1 inputs
C0 & C1 inputs
C1 = 5V
C0 = 5V
C1 = 0V, C0 = 0V
-5
-30
-20
2.8
1.8
19
2.3
0.2
0.1
-1
VOUT
VOUT P
VOUT N
IOUT
SUPPLY
Loaded Output Swing Single Ended
Loaded Output Swing Single Ended
Loaded Output Swing Single Ended
Output Current
RL = 100Ω to GND
RL = 25Ω to GND
RL = 25Ω to GND
RL = 0Ω
±10.3
9.5
-8.2
±10.9
10.2
-9.8
500
VS
IS+ (Full Power)
Supply Voltage
Single supply
Positive Supply Current per Amplifier All outputs at 0V, C0 = C1 = 0V
5
7.5
MAX
UNIT
MHz
dBc
%
°
V/µs
17
mV
10
mV
3.5
MΩ
5
µA
30
µA
20
µA
nV/√ Hz
pA/√ Hz
pA/√ Hz
V
1.5
V
8
µA
4
µA
1
µA
V
V
V
mA
24
V
9
mA
3
FN7013.3
March 26, 2007