PRELIMINARY NSootimcee: pTahriasmisentroict alimfinitaslasrpeescuifbicjeactitotno. change.
MITSUBISHI MICROCOMPUTERS
38B5 Group
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
DATA REQUIRED FOR MASK ORDERS
The following are necessary when ordering a mask ROM produc-
tion:
(1) Mask ROM Order Confirmation Form
(2) Mark Specification Form
(3) Data to be written to ROM, in EPROM form (three identical cop-
ies)
ROM PROGRAMMING METHOD
The built-in PROM of the blank One Time PROM version and the
EPROM version can be read or programmed with a general purpose
PROM programmer using a special programming adapter. Set the
address of PROM programmer in the user ROM area.
Table 9 Special Programming Adapter
Package
Name of Programming Adapter
80P6N-A
PCA7438F-80A
80D0
PCA7438L-80A
The PROM of the blank One Time PROM version is not tested or
screened in the assembly process and following processes. To en-
sure proper operation after programming, the procedure shown in
Figure 72 is recommended to verify programming.
Programming with PROM
programmer
Screening (Note)
(150°C for 40 hours)
Verification with
PROM programmer
Functional check in
target device
Note: The screening temperature is far higher
than the storage temperature. Never
expose to 150 °C exceeding 100 hours.
Fig. 72 Programming and Testing of One Time PROM Version
61