EHP-B03LS 查看數據表（PDF） - EVERLIGHT

零件编号

产品描述 (功能)

生产厂家

EHP-B03LS

High Power LED – 5W

EVERLIGHT 

EVERLIGHT ELECTRONICS CO.,LTD.

4. Soldering Condition

i. Lead reflow soldering temperature profile

EHP-B03LS/UT04-P05/TR

ii. Reflow soldering should not be done more than two times.

iii. While soldering, do not put stress on the LEDs during heating.

iv. After soldering, do not warp the circuit board

5. Soldering Iron

i. For prototype builds or small series production runs it is possible to place and solder the LED by

hand.

ii. Dispensing thermal conductive glue or grease on the substrates and follow its curing spec. Press

LED housing to closely connect LED and substrate.

iii. It is recommended to hand solder the leads with a solder tip temperature of 280°C for less than 3

seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more

intervals, and do soldering of each terminal.

iv. Be careful because the damage of the product is often started at the time of the hand solder.

Everlight Electronics Co., Ltd.

Device No. :

http://www.everlight.com

Prepared date: 08-20-2007

Rev.1.0

Page: 10 of 10

Prepared by: Brady Chou

Share Link: