45878 Просмотр технического описания (PDF) - Unspecified

Номер в каталоге

Компоненты Описание

производитель

45878

BGA & CSP Rework System

Unspecified 

DWG # 2

A

B

3.

Using a 0.05 hex wrench perform tasks A through F.

DWG # 3

A.

B.

C.

D.

E.

F.

DWG # 4

Turn both screws C & D counterclockwise until there is no

effect of this action on the screen. (The image does not move.)

Turn screw D clockwise until the image on the screen starts to move

and turn an additional 65° ± 10° from this point.

Repeat this step for screw C.

Turn both screws E & F counterclockwise until there is no effect of

this motion on the image on the screen. (The image does not shift.)

Turn screw F clockwise until the vertical lines of the component on

the PCB blank are lined up and continuous, not broken.

Turn screw E clockwise until the horizontal lines of the component

on the PCB blank are lined up and continuous, not broken. If you cannot line up the

horizontal lines turn the split adjustment knob and additional 10° - 15°.

Turn split vision knob clockwise 45° and back counterclockwise

until the outline lines up again in both vertical and horizontal

directions. The image should look as in DWG # 4 on the right. If the image looks like

the one on the left, repeat steps A-F.

SCREEN SPLITTING

LINE

Turn the split vision knob clockwise and counterclockwise to ensure that both

corners move toward each other and back and proper alignment is kept.

ADDENDUM B page 5

Share Link: