B84299D6010B003 Просмотр технического описания (PDF) - EPCOS AG

Номер в каталоге

Компоненты Описание

производитель

B84299D6010B003

Power line filter for shielded rooms & secure area

EPCOS AG 

Power line filter

for shielded rooms & secure area

B84299D6***A(B)00*

Cautions and warnings

S Please note the advices in our data book “EMC Filters” (latest edition); attention should be paid to the chapter “General safety notes”.

S It shall be ensured that only qualified persons (electricity specialists) are engaged on work such as planning, assembly, installation, opera-

tion, repair and maintenance. They must be provided with the corresponding documentation.

S Danger of electric shock. EMC filters contain components that store an electric charge. Dangerous voltages can continue to exist at the

filter terminals for longer than five minutes even after the power has been switched off.

S The protective earth connections shall be the first to be made when the EMC filter is installed and the last to be disconnected. Depending

on the magnitude of the leakage currents, the particular specifications for making the protective--earth connection must be observed.

S Impermissible overloading of the EMC filter, such as with circuits able to cause resonances, impermissible voltages at higher frequencies

etc. can lead to bodily injury and death as well as cause substantial material damages (e.g. destruction of the filter housing).

S EMC filters must be protected in the application against impermissible exceeding of the rated currents by overcurrent protective.

S In case of leakage currents > 3.5 mA you shall mount the PE conductor stationary with the required cross section before beginning of op-

eration and save it against disconnecting. For leakage currents IL 4) < 10 mA the PE conductor must have a KU value 3) of 4.5; for leakage

currents IL ኑ 10 mA the PE conductor must have a KU value of 6.

3) The KU value (symbol KU) is a classification parameter of safety--referred failure types designed to ensure protection against hazardous body currents and excessive heating.

A value of KU = 4.5 with respect to interruptions is attained:

-- with a permanently connected protective earth circuit ≥ 1.5 mm2

-- with a protective earth circuit ≥ 2.5 mm2 connected via shroud connectors (IEC 60309--2).

KU = 6 with respect to interruptions is achieved for fixed--connection lines ≥ 10 mm2 where the type of connection and line layout correspond to the requirements for PEN conduc-

tors as specified in relevant standards.

4) IL = leakage current let--go

Important notes

The following applies to all products named in this publication:

1. Some parts of this publication contain statements about the suitability of our products for certain areas of application. These statements

are based on our knowledge of typical requirements that are often placed on our products in the areas of application concerned. We neverthe-

less expressly point out that such statements cannot be regarded as binding statements about the suitability of our products for a

particular customer application. As a rule, EPCOS is either unfamiliar with individual customer applications or less familiar with them than

the customers themselves. For these reasons, it is always ultimately incumbent on the customer to check and decide whether an EPCOS

product with the properties described in the product specification is suitable for use in a particular customer application.

2. We also point out that in individual cases, a malfunction of electronic components or failure before the end of their usual service life

cannot be completely ruled out in the current state of the art, even if they are operated as specified. In customer applications requiring

a very high level of operational safety and especially in customer applications in which the malfunction or failure of an electronic component

could endanger human life or health (e.g. in accident prevention or life--saving systems), it must therefore be ensured by means of suitable

design of the customer application or other action taken by the customer (e.g. installation of protective circuitry or redundancy) that no injury

or damage is sustained by third parties in the event of malfunction or failure of an electronic component.

3. The warnings, cautions and product- specific notes must be observed.

4. In order to satisfy certain technical requirements, some of the products described in this publication may contain substances subject

to restrictions in certain jurisdictions (e.g. because they are classed as hazardous). Useful information on this will be found in our Material

Data Sheets on the Internet (www.epcos.com/material). Should you have any more detailed questions, please contact our sales offices.

5. We constantly strive to improve our products. Consequently, the products described in this publication may change from time to time.

The same is true of the corresponding product specifications. Please check therefore to what extent product descriptions and specifications

contained in this publication are still applicable before or when you place an order.

We also reserve the right to discontinue production and delivery of products. Consequently, we cannot guarantee that all products

named in this publication will always be available. The aforementioned does not apply in the case of individual agreements deviating from the

foregoing for customer--specific products.

6. Unless otherwise agreed in individual contracts, all orders subject to the current version of the “General Terms of Delivery for Products

and Services in the Electrical Industry” published by the the German Electrical and Electronics Industry Association (ZVEI).

7. The trade names EPCOS, BAOKE, Alu--X, CeraDiode, CSMP, CSSP, CTVS, DeltaCap, DigiSiMic, DSSP, FormFit, MiniBlue, MiniCell, MKD,

MKK, MLSC, MotorCAP, PCC, PhaseCap, PhaseCube, PhaseMod, PhiCap, SIFERRIT, SIFI, SIKOREL, SilverCap, SIMDAD, SiMic, SIMID,

SineFormer, SIOV, SIP5D, SIP5K, ThermoFuse, WindCap are trademarks registered or pending in Europe and in other countries. Further

information will be found on the Internet at www.epcos.com/trademarks.

1

Please read Cautions and warnings and

Important notes at the end of this document.

Page 10 of 10

B84299- D6*- A(B)*- 06- 7659

Share Link: