Introduction
The HAL 710 and the HAL 730 are monolithic integrated Hall-effect sensors manufactured in CMOS technology with two independent Hall plates S1 and S2 spaced 2.35 mm apart.

FEATUREs
– generation of Count Signals and Direction Signals
– delay of the Count Signals with respect to the Direction Signal of 1 μs minimum
– switching type: latching
– switching offset compensation at typically 150 kHz
– operation from 3.8 V to 24 V supply voltage
– overvoltage protection at all pins
– reverse-voltage protection at VDD-pin
– robustness of magnetic characteristics against mechanical stress
– short-circuit protected open-drain outputs by thermal shut down
– constant switching points over a wide supply voltage range
– EMC corresponding to ISO 7637