
ETC1
[ULTRACHIP]
Single-Chip, Ultra-Low Power 128COM x 240SEG Matrix Passive LCD Controller-Driver
INTRODUCTION
UC1608 is an advanced high-voltage mixed signal CMOS IC, especially designed for the
display needs of ultra-low power hand-held devices. This chip employs UltraChip’s unique DCC
(Direct Capacitor Coupling) driver architecture to achieve near crosstalk free images.
In addition to low power COM and SEG drivers, UC1608 contains all necessary circuits for high-V
LCD power supply, bias voltage generation, timing generation and graphics data memory.
Advanced circuit design techniques are employed to minimize external component counts
and reduce connector size while achieving extremely low power consumption.
FEATURE HIGHLIGHTS
• Single chip controller-driver supports 128 COM x 240 SEG LCD, with vertical scroll.
• Support industry standard 8080 or 6800 bus protocol in either 8-bit or 4-bit parallel interface.
• Support two multiplexing rates (128, 96).
• Self-configuring 8x charge pump with onchip pumping capacitor requires only 5 external capacitors to operate.
• Flexible data addressing/mapping schemes to support wide ranges of software models and LCD layout placements.
• Software programmable 4 temperature compensation coefficients.
• On-chip bypass capacitor for VLCDmakes VLCDbypass capacitor optional for small LCD panels.
• On-chip Power-ON Reset and Software
RESET commands, make RST pin optional.
• VDD(digital) range: 2.4V ~ 3.3V VDD(analog) range: 2.4V ~ 3.3V LCD VOPrange: 6.5V ~ 15V
• Available in gold bump dies
Bump pitch: 50uM min.
Bump gap: 18uM min.
MAIN APPLICATIONS
• Cellular Phones, Smart Phones, PDA and other battery operated palm top devices
and/or portable Instruments