The MC12022TSA can be used with CMOS synthesizers requiring positive edges to trigger internal counters such as Motorola’s MC145XXX series in a PLL to provide tuning signals up to 1.1GHz in programmable frequency steps. This device is a reduced current drain version of the MC12022A/B with the addition of on–chip output termination.
The MC12022TSB can be used with CMOS synthesizers requiring negative edges to trigger internal counters.
A Divide Ratio Control (SW) permits selection of a 64/65 or 128/129 divide ratio as desired.
The Modulus Control (MC) selects the proper divide number after SW has been biased to select the desired divide ratio.
NOTE: The “B” Version Is Not Recommended for New Designs

• 1.1 GHz Toggle Frequency
• Supply Voltage of 4.5 to 5.5V
• Low–Power 4.0mA Typical
• Operating Temperature Range of –40 to +85°C
• Short Setup Time (tset) 16ns Maximum @ 1.1GHz
• Modulus Control Input Level Is Compatible With Standard CMOS and TTL
• Output Load Resistor on Die