ATF20V8B-10SI 데이터 시트보기 (PDF) - Atmel Corporation

부품명

상세내역

제조사

ATF20V8B-10SI

High-performance EE PLD

Atmel Corporation 

Input Test Waveforms and

Measurement Levels

ATF20V8B(Q)(L)

Output Test Loads

Commercial

tR, tF < 5 ns (10% to 90%)

Pin Capacitance

f = 1 MHz, T = 25°C(1)

Typ

Max

Units

Conditions

CIN

COUT

Note:

5

8

pF

VIN = 0V

6

8

pF

VOUT = 0V

1. Typical values for nominal supply voltage. This parameter is only sampled and is not 100% tested.

Power-up Reset

The registers in the ATF20V8Bs are designed to reset dur-

ing power-up. At a point delayed slightly from VCC crossing

VRST, all registers will be reset to the low state. As a result,

the registered output state will always be high on power-up.

This feature is critical for state machine initialization. How-

ever, due to the asynchronous nature of reset and the

uncertainty of how VCC actually rises in the system, the fol-

lowing conditions are required:

1. The VCC rise must be monotonic,

2. After reset occurs, all input and feedback setup

times must be met before driving the clock pin high,

and

3. The clock must remain stable during tPR.

Preload of Registered Outputs

The ATF16V8B’s registers are provided with circuitry to

allow loading of each register with either a high or a low.

This feature will simplify testing since any state can be

forced into the registers to control test sequencing. A

JEDEC file with preload is generated when a source file

with vectors is compiled. Once downloaded, the JEDEC file

preload sequence will be done automatically by most of the

approved programmers after the programming.

Parameter

tPR

VRST

Description

Power-up Reset Time

Power-up Reset Voltage

Typ Max

600 1,000

3.8 4.5

Units

ns

V

Security Fuse Usage

A single fuse is provided to prevent unauthorized copying

of the ATF20V8B fuse patterns. Once programmed, fuse

verify and preload are inhibited. However, the 64-bit User

Signature remains accessible.

The security fuse should be programmed last, as its effect

is immediate.

Electronic Signature Word

There are 64 bits of programmable memory that are always

available to the user, even if the device is secured. These

bits can be used for user-specific data.

Programming/Erasing

Programming/erasing is performed using standard PLD

programmers. For further information, see the Configurable

Logic Databook, section titled, “CMOS PLD Programming

Hardware and Software Support.”

5

Share Link: