DS2405T(1999) 데이터 시트보기 (PDF) - Dallas Semiconductor -> Maxim Integrated

부품명

상세내역

제조사

DS2405T
(Rev.:1999)

Addressable Switch

Dallas Semiconductor -> Maxim Integrated 

NOTES:

1. All voltages are referenced to ground.

DS2405

2. VPUP = external pullup voltage.

3. Input load is to ground.

4. An additional reset or communication sequence cannot begin until the reset high time has expired.

5. Read data setup time refers to the time the host must pull the 1-Wire bus low to read a bit. Data is

guaranteed to be valid within 1 µs of this falling edge and will remain valid for 14 µs minimum (15

µs total from falling edge on 1-Wire bus).

6. VIH is a function of the external pullup resistor and the VCC supply.

7. Capacitance on the data pin could be 800 pF when power is first applied. If a 5 kΩ resistor is used to

pullup the data line to VCC, 5 µs after power has been applied the parasite capacitance will not affect

normal communications.

8. VIH for PIO pin should always be greater than or equal to VPUP -0.3 volts.

9. Input resistance is to ground.

10. Under certain low voltage conditions VILMAX may have to be reduced to as much as 0.5V to always

guarantee a Presence Pulse.

15 of 15

102299

Share Link: