MAX5395M 데이터 시트보기 (PDF) - Maxim Integrated
부품명
상세내역
제조사
MAX5395M
Maxim Integrated
MAX5395M Datasheet PDF : 17 Pages
| |||
MAX5395
Single, 256-Tap Volatile, I2C, Low-Voltage Linear
Taper Digital Potentiometer
General Description
The MAX5395 single, 256-tap volatile, low-voltage
linear taper digital potentiometer offers three end-to-
end resistance values of 10kΩ, 50kΩ, and 100kΩ.
Potentiometer terminals are independent of supply for
voltages up to 5.25V with single-supply operation from
1.7V to 5.5V (charge pump enabled). User-controlled
shutdown modes allow the H, W, or L terminal to be
opened with the wiper position set to zero-code, mid-
code, full-code, or the value contained in the wiper
register. Ultra-low-quiescent supply current (< 1µA) can
be achieved for supply voltages between 2.6V and 5.5V
by disabling the internal charge pump and not allowing
potentiometer terminals to exceed the supply voltage by
more than 0.3V. The MAX5395 provides a low 50ppm/°C
end-to-end temperature coefficient and features an I2C
serial interface.
The small package size, low operating supply voltage,
low supply current, and automotive temperature range
of the MAX5395 make the device uniquely suited for the
portable consumer market and battery-backup industrial
applications.
The MAX5395 is available in a lead-free, 8-pin TDFN
(2mm x 2mm) package. The device operates over the
-40°C to +125°C automotive temperature range.
Ordering Information appears at end of data sheet.
Benefits and Features
●● Single Linear Taper 256-Tap Positions
●● 10kΩ, 50kΩ, and 100kΩ End-to-End Resistance
●● 1.7V to 5.5V Extended Single Supply
●● 0 to 5.25V H, W, L Operating Voltage Independent of VDD
●● 1μA (typ) Supply Current in Low-Power Mode
●● ±1.0 LSB INL, ±0.5 LSB DNL (max) Wiper Accuracy
●● Power-On Sets Wiper to Midscale
●● 50ppm/°C End-to-End Temperature Coefficient
●● 5ppm/°C Ratiometric Temperature Coefficient
●● -40°C to +125°C Operating Temperature Range
●● 2mm x 2mm, 8-Pin TDFN Package
●● I2C-Compatible Serial Interface
Applications
●● Portable Electronics
●● System Calibration
●● Battery-Powered Systems
●● Mechanical Potentiometer Replacement
Typical Operating Circuit
ADDR0
SDA
SCL
VDD
1.7V TO 5.5V
(CHARGE PUMP ENABLED) H
MAX5395
I2C
W
INTERFACE
+5V
VS
VO
MAX4250
GND
L
R1
VO/ VS = 1 + RMAX5395/R1
19-6393; Rev 3; 2/16
Share Link: 