GENERAL DESCRIPTION
MX25L512E is a CMOS 524,288 bit serial Flash memory, which is configured as 65,536 x 8 internally. MX25L512E features a serial peripheral interface and software protocol allowing operation on a simple 3-wire bus. The three bus signals are a clock input (SCLK), a serial data input (SI), and a serial data output (SO). Serial access to the device is enabled by CS# input.
MX25L512E provides sequential read operation on whole chip.
After program/erase command is issued, auto program/erase algorithms which program/erase and verify the specified page or sector/block locations will be executed. Program command is executed on page (256 bytes) basis, and erase command is executes on chip or sector (4K-bytes).

FEATURES
GENERAL
• Supports Serial Peripheral Interface -- Mode 0 and
   Mode 3
• 524,288 x 1 bit structure or 262,144 x 2 bits (Dual
   Output mode) Structure
• 16 Equal Sectors with 4K byte each
   - Any Sector can be erased individually
• Single Power Supply Operation
   - 2.7 to 3.6 volt for read, erase, and program operations
• Latch-up protected to 100mA from -1V to Vcc +1V

PERFORMANCE
• High Performance
   - Fast access time: 104MHz serial clock
   - Serial clock of Dual Output mode: 80MHz
   - Fast program time: 0.6ms(typ.) and 3ms(max.)/
      page (256-byte per page)
   - Byte program time: 9us
   - Fast erase time: 40ms(typ.)/sector (4K-byte per
      sector); 0.4s(typ.) and 2s(max.)/chip
• Low Power Consumption
   - Low active read current: 12mA(max.) at 104MHz
      and 4mA(max.) at 33MHz
   - Low active programming current: 15mA (typ.)
   - Low active sector erase current: 9mA (typ.)
   - Low standby current: 15uA (typ.)
   - Deep power-down mode 2uA (typ.)
• Minimum 100,000 erase/program cycles
• 20 years data retention

(Continue ...)