L1Q0-507000000ZZZ0 データシートの表示（PDF） - Lumileds Lighting Company

部品番号

コンポーネント説明

メーカー

L1Q0-507000000ZZZ0

Standard ceramic 3535 footprint delivering high efficacy at high-drive current

Lumileds Lighting Company 

Electrical Characteristics

Electrical Characteristics at test current for LUXEON Q

Junction Temperature = 85°C

Table 3.

Nominal

ANSI CCT

Forward Voltage V (V) [1]

f

Minimum

Maximum

R 2700K

3000K

3500K

E 4000K

E 5000K

5700K

2.50

2.50

2.50

2.50

2.50

2.50

G L Notes forTable 3:

1. Lumileds maintains a tolerance of ± 0.06V on forward voltage measurements.

2. Measured between T = 25°C and T = 110°C at I = 350mA.

J

J

f

3.25

3.25

3.25

3.25

3.25

3.25

Typical Temperature

Coefficient

of Forward Voltage [2]

(mV/°C)

DVF / DTJ

-1.6

-1.6

-1.6

-1.6

-1.6

-1.6

Typical Thermal Resistance

Junction to Thermal Pad

(°C/W)

Rθ J-C

7

7

7

7

7

7

Absolute Maximum Ratings N B Table 4.

O A Parameter

DC Forward Current (mA) [1] [2]

Peak Pulsed Forward Current (mA) [1] [3]

L R ESD Sensitivity

LED Junction Temperature [1]

Operating Case Temperature at 700mA

E Storage Temperature

Soldering Temperature

Allowable Reflow Cycles

OReverse Voltage (Vr) [4] [5]

LUXEON Q

1050

1200

< 8000V Human Body Model (HBM) Class 3A JESD22-A114-E

135°C

-40°C - 135°C

-40°C - 135°C

JEDEC 020c 260°C

3

LUXEON Q LEDs are not designed to be driven in reverse bias

D Notes for Table 4:

1. Proper current derating must be observed to maintain junction temperature below the maximum. For additional information on thermal measurement guidelines please refer to Application

Brief AB118 (not available yet).

2. Residual periodic variations due to power conversion from alternating current (AC) to direct current (DC), also called “ripple”, with frequencies

N R ≥ 100 Hz and amplitude ≤ 150mA are acceptable, assuming the average current throughout each cycle does not exceed 1050mA.

3. Pulsed operation with a peak drive current of 1200mA is acceptable if the pulse on-time is ≤ 5 ms per cycle and the duty cycle is ≤ 50%.

4. Transient reverse voltages and surge currents due to electrical switching or supply interruptions are acceptable if these events do not last for more than 10ms, the amplitude of the reverse

voltage does not exceed 5V and the reverse current is less than 200μA.

O 5. Max 5V reverse for up to 10s is an acceptable beginning of life, one time test condition.

DS118 LUXEON Q Product Datasheet 20180327 ©2018 Lumileds Holding B.V. All rights reserved.

4

Share Link: