LAX100-NP データシートの表示（PDF） - LEM Industrial

部品番号

コンポーネント説明

メーカー

LAX100-NP

Current Transducer

LEM Industrial 

Dimensions LAX 100-NP (in mm. General linear tolerance ± 0.15 mm)

Assembly on PCB

Safety

• Recommended PCB hole diameter 2 mm (0/+0.1) for primary pins

1 mm (0/+0.1) for secondary pins

• Maximum PCB thickness

2.4 mm

• Solder temperature

maximum 270°C for 15 s (wave

soldering)

• No-clean process only

This transducer must be used in electric/electronic equipment with respect

to applicable standards and safety requirements in accordance with the

following manufacturer's operating instructions.

Remarks

• IS is positive (sourcing) when IP flows in the direction of the arrow

• Mass: 20 g

Caution, risk of electrical shock

When operating the transducer, certain parts of the module can carry

hazardous voltage (eg. primary busbar, power supply).

Ignoring this warning can lead to injury and/or cause serious damage.

This transducer is a built-in device, whose conducting parts must be

inaccessible after installation.

A protective housing or additional shield could be used.

Main supply must be able to be disconnected.

070213/7

LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice.

Page 12/12

www.lem.com

Share Link: