Call Progress Decoder
13
6.2 Timing
For the following conditions unless otherwise specified:
Xtal Frequency = 3.579545MHz, VDD = 3.3V to 5.0V, TAMB = 25°C.
tRP
tDRP
tNRP
tNDRP
tI
tL
tGI
tGD
tNG
tDI
tDE
tHIZ
tIR
tIP
Parameter
Call Progress Tone Response Time
Call Progress Tone De-response Time
Non Call Progress Signal Response Time
Non Call Progress Signal De-response Time
Burst Length Ignored
Burst Length Detected
Call Progress Tone Gap Length Ignored
Call Progress Tone Gap Length Detected
Non Call Progress Signal Gap Length Ignored
Data available to Interrupt pulse
" CS -Low " to Data Valid
" CS -High" to Output Tri-state
Interrupt Reset Time
Interrupt Low Pulse
Notes
1
1
1
1
1, 2, 3,
1, 2
4
Min.
145
145
40
4.0
MX663 Preliminary Information
Typ.
Max.
145
145
80
70
20
80
430
0.2
1.0
0.2
5.0 6.0
Units
ms
ms
ms
ms
ms
ms
ms
ms
ms
µs
µs
µs
µs
µs
Notes:
1. Timing also applies to Special Information Tones and Fax/modem Tones.
2. Only applies to burst of the same frequency.
3. For Special Information Tones and Fax/Modem tones, tGI is 15ms maximum.
4. If the gap > 90ms, a NO Signal state will be detected.
SIGIN
tI
tL
No Signal Call Progress
Single Tone
CPTone
620Hz
tGD
CPTone
620Hz
tGI
CPTone
620Hz
ENABLE
tRP
tDRP
Tri-state
D0
tDE
D1
D2
See Note 1
D3
"0"
CS
"0"
IRQ
tDI
tDI
tRP
tIP
Tri-state
tHIZ
Note
1. D2 is '1' only when the Call Progress signal, or a Non Call Progress signal, is a single frequency tone.
Figure 4: Timing Diagram: Call Progress Tone(s)
© 1999 MX-COM Inc.
www.mxcom.com Tele: 800 638-5577 336 744-5050 Fax: 336 744-5054
Doc. # 20480165.003
4800 Bethania Station Road, Winston-Salem, NC 27105-1201 USA
All trademarks and service marks are held by their respective companies.