MAX545B データシートの表示（PDF） - Maxim Integrated

部品番号

コンポーネント説明

メーカー

MAX545B

+5V, Serial-Input, Voltage-Output, 14-Bit DACs

Maxim Integrated 

+5V, Serial-Input, Voltage-Output, 14-Bit DACs

Digital Interface

The MAX544/MAX545’s digital interface is a standard

3-wire connection compatible with SPI/QSPI/

MICROWIRE interfaces. The chip-select input (CS)

frames the serial data loading at the data-input pin

(DIN). Immediately following CS’s high-to-low transition,

the data is shifted synchronously and latched into the

input register on the rising edge of the serial clock input

(SCLK). After 16 bits (14 data bits, plus 2 sub-bits set to

zero) have been loaded into the serial input register, it

transfers its contents to the DAC latch on CS’s low-to-

high transition (Figure 3a). Note that if CS is not kept

low during the entire 16 SCLK cycles, data will be cor-

rupted. In this case, reload the DAC latch with a new

16-bit word.

Alternatively, for the MAX545, LDAC allows the DAC

latch to update asynchronously by pulling LDAC low

after CS goes high (Figure 3b). Hold LDAC high during

the data-loading sequence.

External Reference

The MAX544/MAX545 operate with external voltage ref-

erences from 2V to 3V. The reference voltage deter-

mines the DAC’s full-scale output voltage. Kelvin

connections are provided with the MAX545 for optimum

performance. The 2.5V MAX873A, with ±15mV initial

accuracy and a 7ppm/°C (max) temperature coeffi-

cient, is a good choice.

Power-On Reset

The MAX544/MAX545 have a power-on reset circuit to

set the DAC’s output to 0V in unipolar mode when VDD

is first applied. This ensures that unwanted DAC output

voltages will not occur immediately following a system

power-up, such as after a loss of power. In bipolar

mode, the DAC output is set to -VREF.

CS

; ; ;; SCLK

DIN

DAC

UPDATED

D13 D12 D11 D10 D9 D8 D7 D6

SUB-BITS

D5 D4 D3 D2 D1 D0 S1 S0

MSB

LSB

Figure 3a. MAX544/MAX545 3-Wire Interface Timing Diagram (LDAC = DGND for MAX545)

; ;; ;;; CS

SCLK

DIN

D13 D12 D11 D10 D9 D8 D7 D6

MSB

SUB-BITS

D5 D4 D3 D2 D1 D0 S1 S0

LSB

LDAC

Figure 3b. MAX545 4-Wire Interface Timing Diagram

DAC

UPDATED

8 _______________________________________________________________________________________

Share Link: