HAL1002 データシートの表示（PDF） - Micronas

部品番号

コンポーネント説明

メーカー

HAL1002

Programmer Board

Micronas 

APPLICATION NOTE

2.4. The COM Port Parameters

HAL8xy, HAL100x

Programmer Board

The basic parameters for the setup of the serial communication are described in

Table 2–1.

Table 2–1: COM port parameters

Parameter

Baud rate

Data bits

Stop bits

Parity

Flow control

Value

9600

57600

8

1

EVEN

NONE

Remarks

Jumper ’BaudRate’ set

Jumper ’BaudRate’ open

2.5. Connectors

Up to four sensors can be connected to the programmer board V 5.1. For this purpose,

two 6-pin connectors, HAL 1/2 and HAL 3/4, are supplied.

Note: In case of HAL 810, HAL 856 and HAL 1000 only one sensor can be connected

to the board. These sensors do not support the required multi-programming

function.

Alternatively, one Hall sensor can be inserted in the three-pin socket HAL beneath the

connector HAL 1/2. The pins of this socket are connected parallel to pins 1, 3, and 5 of

the connector HAL 1/2.

The male plug (Amp 215083) corresponding to the red connectors HAL 1/2 and HAL 3/

4 can be ordered from Bürklin with the order no. 58F462.

1

3

5

2

4

6

Fig. 2–1: Interface connector HAL 1/2 (HAL 3/4).

Micronas

Sept. 19, 2013; APN000046_03EN

9

Share Link: