C8051F363 データシートの表示（PDF） - Silicon Laboratories

部品番号

コンポーネント説明

メーカー

C8051F363

Mixed Signal ISP Flash MCU Family

Silicon Laboratories 

C8051F360/1/2/3/4/5/6/7/8/9

22.2.5. 8-Bit Pulse Width Modulator Mode

Each module can be used independently to generate pulse width modulated (PWM) outputs on its associ-

ated CEXn pin. The frequency of the output is dependent on the timebase for the PCA0 counter/timer. The

duty cycle of the PWM output signal is varied using the module's PCA0CPLn capture/compare register.

When the value in the low byte of the PCA0 counter/timer (PCA0L) is equal to the value in PCA0CPLn, the

output on the CEXn pin will be high. When the count value in PCA0L overflows, the CEXn output will be

low (see Figure 22.8). Also, when the counter/timer low byte (PCA0L) overflows from 0xFF to 0x00,

PCA0CPLn is reloaded automatically with the value stored in the counter/timer's high byte (PCA0H) with-

out software intervention. Setting the ECOMn and PWMn bits in the PCA0CPMn register enables 8-Bit

Pulse Width Modulator mode. The duty cycle for 8-Bit PWM Mode is given by Equation 22.2.

Equation 22.2. 8-Bit PWM Duty Cycle

DutyCycle

=

(---2---5---6----–-----P----C----A----0----C----P----H-----n----)

256

Using Equation 22.2, the largest duty cycle is 100% (PCA0CPHn = 0), and the smallest duty cycle is

0.39% (PCA0CPHn = 0xFF). A 0% duty cycle may be generated by clearing the ECOMn bit to ‘0’.

Important Note About Capture/Compare Registers: When writing a 16-bit value to the PCA0 Capture/

Compare registers, the low byte should always be written first. Writing to PCA0CPLn clears the ECOMn bit

to ‘0’; writing to PCA0CPHn sets ECOMn to ‘1’.

PCA0CPHn

PCA0CPMn

P ECCMT P E

WCA A AOWC

MOPP TGMC

1 MPN n n n F

6nnn

n

n

0 0000 0

PCA0CPLn

Enable

8-bit

Comparator

match S SET Q

PCA Timebase

PCA0L

Overflow

RQ

CLR

CEXn Crossbar

Figure 22.8. PCA 8-Bit PWM Mode Diagram

Port I/O

Rev. 1.0

271

Share Link: