AD9211 データシートの表示（PDF） - Analog Devices
部品番号
コンポーネント説明
メーカー
AD9211 Datasheet PDF : 28 Pages
| |||
AD9211
MEMORY MAP
READING THE MEMORY MAP TABLE
Each row in the memory map table has eight address locations.
The memory map is roughly divided into three sections: chip
configuration register map (Address 0x00 to Address 0x02),
transfer register map (Address 0xFF), and program register map
(Address 0x08 to Address 0x2A).
The Addr. (Hex) column of the memory map indicates the
register address in hexadecimal, and the Default Value (Hex)
column shows the default hexadecimal value that is already
written into the register. The Bit 7 (MSB) column is the start of
the default hexadecimal value given. For example, Hexadecimal
Address 0x09, clock, has a hexadecimal default value of 0x01.
This means Bit 7 = 0, Bit 6 = 0, Bit 5 = 0, Bit 4 = 0, Bit 3 = 0,
Bit 2 = 0, Bit 1 = 0, and Bit 0 = 1, or 0000 0001 in binary. The
default value enables the duty cycle stabilizer. Overwriting this
default so that Bit 0 = 0 disables the duty cycle stabilizer. For more
information on this and other functions, consult the AN-877
application note, Interfacing to High Speed ADCs via SPI.
RESERVED LOCATIONS
Undefined memory locations should not be written to other
than their default values suggested in this data sheet. Addresses
that have values marked as 0 should be considered reserved and
have a 0 written into their registers during power-up.
DEFAULT VALUES
Coming out of reset, critical registers are preloaded with default
values. These values are indicated in Table 13. Other registers
do not have default values and retain the previous value when
exiting reset.
LOGIC LEVELS
An explanation of various registers follows: “Bit is set” is
synonymous with “bit is set to Logic 1” or “writing Logic 1 for
the bit.” Similarly, “clear a bit” is synonymous with “bit is set to
Logic 0” or “writing Logic 0 for the bit.”
Table 13. Memory Map Register
Addr.
Bit 7
(Hex) Parameter Name (MSB)
Chip Configuration Registers
00
chip_port_config 0
Bit 6
LSB
first
Bit 5
Soft
reset
01
chip_id
02
chip_grade
0
Transfer Register
FF
device_update
0
0
0
0
0
Bit 4
1
Bit 3
1
Bit 2
Soft
reset
8-bit chip ID, Bits[7:0]
AD9211 = 0x06
Speed grade:
X
00 = 300 MSPS
01 = 250 MSPS
10 = 200 MSPS
0
0
0
Bit 1
Bit 0
(LSB)
LSB first 0
X
X
Default
Value
(Hex)
Default Notes/
Comments
0x18
Read-
only
Read-
only
The nibbles
should be
mirrored by the
user so that LSB
or MSB first
mode registers
correctly,
regardless of
shift mode.
Default is unique
chip ID, different
for each device.
This is a read-
only register.
Child ID used to
differentiate
graded devices.
0
SW
0x00
Synchronously
transfer
transfers data
from the master
shift register to
the slave.
Rev. 0 | Page 25 of 28
Share Link: 