EHP-A07/SUG01H-P01/TR Ver la hoja de datos (PDF) - Unspecified

Número de pieza

componentes Descripción

fabricante

EHP-A07/SUG01H-P01/TR

High Power LED – 1W

Unspecified 

EHP-A07/SUG01H-P01/TR

High Power LED – 1W

5. Soldering Iron

i. For Reflow Process

a. EHP-A07 series are suitable for SMT process.

b. Curing of glue in oven according to standard operation flow processes.

c. Reflow soldering should not be done more than twice.

d. In soldering process, stress on the LEDs during heating should be avoided.

e. After soldering, do not warp the circuit board.

ii. For Manual Soldering Process

a. For prototype builds or small series production runs it is possible to place and solder the

LED by hand.

b. Dispense thermal conductive glue or grease on the substrates and follow its curing

specifications. Gently press LED housing to closely connect LED and substrate.

c. It is recommended to hand solder the leads with a solder tip temperature of 280°C for

less than 3 second, at a time with a soldering iron of less than 25W. Solder at intervals of

two seconds or more.

d. Take caution and be aware that damaged products are often a result of improper hand

soldering technique.

14 of 15

Share Link: