MPC5566MVR80 Ver la hoja de datos (PDF) - Freescale Semiconductor

Número de pieza

componentes Descripción

fabricante

MPC5566MVR80

Microcontroller

Freescale Semiconductor 

Electrical Characteristics

3.7.1 Input Value of Pins During POR Dependent on VDD33

When powering up the device, VDD33 must not lag the latest VDDSYN or RESET power pin (VDDEH6) by

more than the VDD33 lag specification listed in Table 6, spec 8. This avoids accidentally selecting the

bypass clock mode because the internal versions of PLLCFG[0:1] and RSTCFG are not powered and

therefore cannot read the default state when POR negates. VDD33 can lag VDDSYN or the RESET power

pin (VDDEH6), but cannot lag both by more than the VDD33 lag specification. This VDD33 lag specification

applies during power up only. VDD33 has no lead or lag requirements when powering down.

3.7.2 Power-Up Sequence (VRC33 Grounded)

The 1.5 V VDD power supply must rise to 1.35 V before the 3.3 V VDDSYN power supply and the RESET

power supply rises above 2.0 V. This ensures that digital logic in the PLL for the 1.5 V power supply does

not begin to operate below the specified operation range lower limit of 1.35 V. Because the internal 1.5 V

POR is disabled, the internal 3.3 V POR or the RESET power POR must hold the device in reset. Since

they can negate as low as 2.0 V, VDD must be within specification before the 3.3 V POR and the RESET

POR negate.

VDDSYN and RESET Power

VDD

2.0 V

1.35 V

VDD must reach 1.35 V before VDDSYN and the RESET power reach 2.0 V

Figure 3. Power-Up Sequence (VRC33 Grounded)

3.7.3 Power-Down Sequence (VRC33 Grounded)

The only requirement for the power-down sequence with VRC33 grounded is if VDD decreases to less than

its operating range, VDDSYN or the RESET power must decrease to less than 2.0 V before the VDD power

increases to its operating range. This ensures that the digital 1.5 V logic, which is reset only by an ORed

POR and can cause the 1.5 V supply to decrease less than its specification value, resets correctly. See

Table 6, footnote 1.

MPC5566 Microcontroller Data Sheet, Rev. 3

Freescale

13

Share Link: