LTC3225-1 Ver la hoja de datos (PDF) - Linear Technology
Número de pieza
componentes Descripción
fabricante
LTC3225-1 Datasheet PDF : 14 Pages
| |||
LTC3225/LTC3225-1
SIMPLIFIED BLOCK DIAGRAM
CFLY
9
1
2
4
VIN
C+
C–
SHDN
VIN
SOFT-START AND
SHUTDOWN CONTROL
UVLO
THERMAL
PROTECTION
PROG
7
RPROG
1.2V
RUN
i
3000i
CHARGE
PUMP
CLK
RUN/STOP
OSCILLATOR
POR
COUT 10
CX
3
CTOP
GND
8
CBOT
R1
1.2V
VREF
1.088V (LTC3225)
1.067V (LTC3225-1)
VSEL
6
C1
VREF – 2%
VREF – 6%
VREF – 7.2%
R2
+
C2
–
POR
PGOOD
5
Figure 1
3225 F01
OPERATION
The LTC3225/LTC3225-1 are dual cell supercapacitor char-
gers. Their unique topology maintains a constant output
voltage with programmable charge current. Their ability
to maintain equal voltages on both cells while charging
protects the supercapacitors from damage that is possible
with other charging methods, without the use of external
balancing resistors. The LTC3225/LTC3225-1 include an
internal switched capacitor charge pump to boost VIN to a
regulated output voltage. A unique architecture maintains
relatively constant input current for the lowest possible
input noise. The basic charger circuit requires only three
external components.
6
Normal Charge Cycle
Operation begins when the SHDN pin is pulled above 1.3V.
The COUT pin voltage is sensed and compared with a preset
voltage threshold using an internal resistor divider and
a comparator. The preset voltage threshold is selectable
with the VSEL pin. If the voltage at the COUT pin is lower
than the preset voltage threshold, the oscillator is enabled.
The oscillator operates at a typical frequency of 0.9MHz.
When the oscillator is enabled, the charge pump operates
charging up COUT. Each time the charge pump starts up
from shutdown, the input current drawn by the internal
charge pump ramps up at approximately 20mA/μs until it
reaches a level which is determined by RPROG.
3225fb
Share Link: 