CY14B101I Ver la hoja de datos (PDF) - Cypress Semiconductor
Número de pieza
componentes Descripción
fabricante
CY14B101I Datasheet PDF : 42 Pages
| |||
PRELIMINARY
CY14C101I
CY14B101I, CY14E101I
Figure 34. Random Control Registers Multi-Byte Read
By Master
SDA Line
By nvSRAM
S
T
A
Control Registers
R
Slave Address
T
S 0 0 1 1 A2 A1 X 0
Control Register Address
Control Registers Slave Address
Sr 0 0 1 1 A2 A1 X 1
A
A
A
S
A
T
0
P
P
A
Data Byte
Data Byte N
Serial Number
Serial number is an 8 byte memory space provided to the user
to uniquely identify this device. It typically consists of a two byte
customer ID, followed by five bytes of unique serial number and
one byte of CRC check. However, nvSRAM does not calculate
the CRC and it is up to the user to utilize the eight byte memory
space in the desired format. The default values for the eight byte
locations are set to ‘0x00’.
Serial Number Write
The serial number can be accessed through the Control
Registers Slave Device. To write the serial number, master
transmits the Control Registers Slave address after the START
condition and writes to the address location from 0x01 to 0x08.
The content of Serial Number registers is secured to nonvolatile
memory on the next STORE operation. If AutoStore is enabled,
nvSRAM automatically stores the Serial number in the nonvol-
atile memory on power-down. However, if AutoStore is disabled,
user must perform a STORE operation to secure the contents of
Serial Number registers.
Note If the serial number lock (SNL) bit is not set, the serial
number registers can be re-written regardless of whether or not
a STORE has happened. Once the serial number lock bit is set,
no writes to the serial number registers are allowed. If the master
tries to perform a write operation to the serial number registers
when the lock bit is set, a NACK is returned and write will not be
performed.
Serial Number Lock
After writes to Serial Number registers is complete, master is
responsible for locking the serial number by setting the serial
number lock bit to ‘1’ in the Memory Control Register (0x00). The
content of Memory Control Register and serial number are
secured on the next STORE operation (STORE or AutoStore). If
AutoStore is not enabled, user must perform STORE operation
to secure the lock bit status.
If a STORE was not performed, the serial number lock bit will not
survive power cycle. The serial number lock bit and 8 - byte serial
number is defaults to ‘0’ at power-up.
Serial Number Read
Serial number can be read back by a read operation of the
intended address of the Control Registers Slave. The Control
Registers Device loops back from the last address (excluding the
Command Register) to 0x00 address location while performing
burst read operation. The serial number resides in the locations
from 0x01 to 0x08. Even if the serial number is not locked, a
serial number read operation will return the current values written
to the serial number registers. The Master may perform a serial
number read operation to confirm if the correct serial number is
written to the registers before setting the lock bit.
Document #: 001-54391 Rev. *C
Page 19 of 42
[+] Feedback
Share Link: 