MAX4040ESA Ver la hoja de datos (PDF) - Maxim Integrated

Número de pieza

componentes Descripción

fabricante

MAX4040ESA

Single/Dual/Quad, Low-Cost, SOT23, Micropower Rail-to-Rail I/O Op Amps

Maxim Integrated 

Single/Dual/Quad, Low-Cost, SOT23,

Micropower, Rail-to-Rail I/O Op Amps

VIN

R3

R3 = R1 R2

R1

MAX4040–

MAX4044

R2

Figure 1a. Minimizing Offset Error Due to Input Bias Current

(Noninverting)

R3

R3 = R1 R2

VIN

R1

MAX4040–

MAX4044

R2

Figure 1b. Minimizing Offset Error Due to Input Bias Current

(Inverting)

The MAX4040–MAX4044 family’s inputs are protected

from large differential input voltages by internal 2.2kΩ

series resistors and back-to-back triple-diode stacks

across the inputs (Figure 2). For differential input volt-

ages (much less than 1.8V), input resistance is typically

45MΩ. For differential input voltages greater than 1.8V,

input resistance is around 4.4kΩ, and the input bias

current can be approximated by the following equation:

IBIAS = (VDIFF - 1.8V) / 4.4kΩ

In the region where the differential input voltage

approaches 1.8V, the input resistance decreases expo-

nentially from 45MΩ to 4.4kΩ as the diode block begins

conducting. Conversely, the bias current increases with

the same curve.

Rail-to-Rail Output Stage

The MAX4040–MAX4044 output stage can drive up to a

25kΩ load and still swing to within 60mV of the rails.

Figure 3 shows the output voltage swing of a MAX4040

configured as a unity-gain buffer, powered from a single

+4.0V supply voltage. The output for this setup typically

swings from (VEE + 10mV) to (VCC - 10mV) with a 100kΩ

load.

Applications Information

Power-Supply Considerations

The MAX4040–MAX4044 operate from a single +2.4V to

+5.5V supply (or dual ±1.2V to ±2.75V supplies) and

consume only 10µA of supply current per amplifier. A

high power-supply rejection ratio of 85dB allows the

amplifiers to be powered directly off a decaying battery

voltage, simplifying design and extending battery life.

Power-Up Settling Time

The MAX4040–MAX4044 typically require 200µs to

power up after VCC is stable. During this start-up time,

the output is indeterminant. The application circuit

should allow for this initial delay.

IN+

2.2k

IN-

2.2k

Figure 2. Input Protection Circuit

_______________________________________________________________________________________ 9

Share Link: