Overview
The ATtiny25/45/85 is a low-power CMOS 8-bit microcontroller based on the AVR enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATtiny25/45/85 achieves throughputs approaching 1 MIPS per MHz allowing the system designer to optimize power consumption versus processing speed.

FEATUREs
• High Performance, Low Power AVR® 8-Bit Microcontroller
• Advanced RISC Architecture
   – 120 Powerful Instructions – Most Single Clock Cycle Execution
   – 32 x 8 General Purpose Working Registers
   – Fully Static Operation
• Non-volatile Program and Data Memories
   – 2/4/8K Byte of In-System Programmable Program Memory Flash (ATtiny25/45/85) Endurance: 10,000 Write/Erase Cycles
   – 128/256/512 Bytes In-System Programmable EEPROM (ATtiny25/45/85) Endurance: 100,000 Write/Erase Cycles
   – 128/256/512 Bytes Internal SRAM (ATtiny25/45/85)
   – Programming Lock for Self-Programming Flash Program and EEPROM Data Security
• Peripheral Features
   – 8-bit Timer/Counter with Prescaler and Two PWM Channels
   – 8-bit High Speed Timer/Counter with Separate Prescaler
     2 High Frequency PWM Outputs with Separate Output Compare Registers
     Programmable Dead Time Generator
   – Universal Serial Interface with Start Condition Detector
   – 10-bit ADC
     4 Single Ended Channels
     2 Differential ADC Channel Pairs with Programmable Gain (1x, 20x)
   – Programmable Watchdog Timer with Separate On-chip Oscillator
   – On-chip Analog Comparator
• Special Microcontroller Features
   – debugWIRE On-chip Debug System
   – In-System Programmable via SPI Port
   – External and Internal Interrupt Sources
   – Low Power Idle, ADC Noise Reduction, and Power-down Modes
   – Enhanced Power-on Reset Circuit
   – Programmable Brown-out Detection Circuit
   – Internal Calibrated Oscillator
• I/O and Packages
   – Six Programmable I/O Lines
   – 8-pin PDIP and 8-pin SOIC
• Operating Voltage
   – 1.8 - 5.5V for ATtiny25/45/85V
   – 2.7 - 5.5V for ATtiny25/45/85
• Speed Grade
   – ATtiny25/45/85V: 0 - 4 MHz @ 1.8 - 5.5V, 0 - 10 MHz @ 2.7 - 5.5V
   – ATtiny25/45/85: 0 - 10 MHz @ 2.7 - 5.5V, 0 - 20 MHz @ 4.5 - 5.5V
• Industrial Temperature Range
• Low Power Consumption
   – Active Mode:
      1 MHz, 1.8V: 450µA
   – Power-down Mode:
      0.1µA at 1.8V