General Description
   The A29010 is a 5.0 volt-only Flash memory organized as 131,072 bytes of 8 bits each. The 128 Kbytes of data are further divided into four sectors for flexible sector erase capability. The 8 bits of data appear on I/O0 - I/O7 while the addresses are input on A0 to A16. The A29010 is offered in 32- pin PLCC, TSOP, and PDIP packages. This device is designed to be programmed in-system with the standard system 5.0 volt VCC supply. Additional 12.0 volt VPP is not required for insystem write or erase operations. However, the A29010 can also be programmed in standard EPROM programmers.

FEATUREs
◾ 5.0V ± 10% for read and write operations
◾ Access times:
   - 55/70/90 (max.)
◾ Current:
   - 20 mA typical active read current
   - 30 mA typical program/erase current
   - 1 μA typical CMOS standby
◾ Flexible sector architecture
   - 32 KbyteX4 sectors
   - Any combination of sectors can be erased
   - Supports full chip erase
   - Sector protection:
      A hardware method of protecting sectors to prevent
      any inadvertent program or erase operations within that
      sector
◾ Embedded Erase Algorithms
   - Embedded Erase algorithm will automatically erase the
      entire chip or any combination of designated sectors
      and verify the erased sectors
   - Embedded Program algorithm automatically writes and
      verifies bytes at specified addresses
◾ Minimum 100,000 program/erase cycles per sector
◾ 20-year data retention at 125°C
   - Reliable operation for the life of the system
◾ Compatible with JEDEC-standards
   - Pinout and software compatible with 
      single-power-supply Flash memory standard
   - Superior inadvertent write protection
◾ Data Polling and toggle bits
   - Provides a software method of detecting completion of
      program or erase operations
◾ Erase Suspend/Erase Resume
   - Suspends a sector erase operation to read data from,
      or program data to, a non-erasing sector, then
      resumes the erase operation
◾ Package options
   - 32-pin P-DIP, PLCC, or TSOP(Forward type)
◾ Industrial operating temperature range:
   -40°C to 85°C for -U