LT1424-9 View Datasheet(PDF) - Linear Technology
Part Name
Description
MFG CO.
LT1424-9 Datasheet PDF : 16 Pages
| |||
TYPICAL PERFOR A CE CHARACTERISTICS
Minimum Switch On Time
vs Temperature
275
250
225
200
175
150
125
100
– 50 – 25
0 25 50 75
TEMPERATURE (°C)
100 125
1424-9 G10
Flyback Enable Delay Time
vs Temperature
250
225
200
175
150
125
100
75
– 50 – 25
0 25 50 75
TEMPERATURE (°C)
100 125
1424-9 G11
LT1424-9
Minimum Flyback Enable Time
vs Temperature
275
250
225
200
175
150
125
100
– 50 – 25
0 25 50 75
TEMPERATURE (°C)
100 125
1424-9 G12
PIN FUNCTIONS
SHDN (Pin 1): Shutdown. This pin is used to turn off the
regulator and reduce VIN input current to a few tens of
microamperes. The SHDN pin can be left floating when
unused.
VC (Pin 2): Control Voltage. This pin is the output of the
feedback amplifier and the input of the current compara-
tor. Frequency compensation of the overall loop is effected
by placing a capacitor between this node and ground.
SYNC (Pin 3): Pin to synchronize internal oscillator to
external frequency reference. It is directly logic compat-
ible and can be driven with any signal between 10% and
90% duty cycle. If unused, this pin should be tied to
ground.
SGND (Pin 4): Signal Ground. This pin is a clean ground.
The internal reference and feedback amplifier are referred
to it. Keep the ground path connection to the VC compen-
sation capacitor free of large ground currents.
PGND (Pin 5): Power Ground. This pin is the emitter of the
power switch device and has large currents flowing through
it. It should be connected directly to a good quality ground
plane.
VSW (Pin 6): This is the collector node of the output switch
and has large currents flowing through it. Keep the traces
to the switching components as short as possible to
minimize electromagnetic radiation and voltage spikes.
VIN (Pin 7): Supply Voltage. Bypass input supply pin with
10µF or more. The part goes into undervoltage lockout
when VIN drops below 2.8V. Undervoltage lockout stops
switching and pulls the VC pin low.
RCCOMP (Pin 8): Pin for the External Filter Capacitor for
Load Compensation Function. A common 0.1µF
ceramic capacitor will suffice.
sn14249 14249fs
5
Share Link: 