TS80C52X2-MCAR View Datasheet(PDF) - Temic Semiconductors
Part Name
Description
MFG CO.
TS80C52X2-MCAR Datasheet PDF : 54 Pages
| |||
TS80C52X2
MNEMONIC
ALE/PROG
PSEN
EA/VPP
XTAL1
XTAL2
Table 3. Pin Description for 40/44 pin packages
PIN NUMBER
30 33
27
29 32
26
31 35
29
19 21
15
18 20
14
TYPE
NAME AND FUNCTION
O (I)
Address Latch Enable/Program Pulse: Output pulse for latching the low byte
of the address during an access to external memory. In normal operation, ALE
is emitted at a constant rate of 1/6 (1/3 in X2 mode) the oscillator frequency,
and can be used for external timing or clocking. Note that one ALE pulse is
skipped during each access to external data memory. This pin is also the program
pulse input (PROG) during EPROM programming. ALE can be disabled by
setting SFR’s AUXR.0 bit. With this bit set, ALE will be inactive during internal
fetches.
O Program Store ENable: The read strobe to external program memory. When
executing code from the external program memory, PSEN is activated twice each
machine cycle, except that two PSEN activations are skipped during each access
to external data memory. PSEN is not activated during fetches from internal
program memory.
I External Access Enable/Programming Supply Voltage: EA must be externally
held low to enable the device to fetch code from external program memory
locations 0000H and 3FFFH (RB) or 7FFFH (RC), or FFFFH (RD). If EA is
held high, the device executes from internal program memory unless the program
counter contains an address greater than 3FFFH (RB) or 7FFFH (RC) EA must
be held low for ROMless devices. This pin also receives the 12.75V programming
supply voltage (VPP) during EPROM programming. If security level 1 is
programmed, EA will be internally latched on Reset.
I Crystal 1: Input to the inverting oscillator amplifier and input to the internal
clock generator circuits.
O Crystal 2: Output from the inverting oscillator amplifier
6
Rev. B - Jan. 25, 1999
Preliminary
Share Link: 