SP8542 View Datasheet(PDF) - Signal Processing Technologies

Part Name

Description

MFG CO.

SP8542

Two and Four Channel 12-Bit Multiplexed Sampling ADCs

Signal Processing Technologies 

CH0

CH1

0.01µF*

1 N.C.

GAIN ADJUST 16

2 CH0

REF OUT 15

3 CH1

OFFSET ADJ. 14

4 AGND

VDA 13

5 VSS SP8542 VDD 12

6 SCLK

SD 11

7 DOUT

8 DIN

CS 10

STATUS 9

10kOhms

5kOhms

+5V

0.1µF

0.1µF

+

6.8µF

2kOhms

CLOCK IN

DATA OUT

DATA IN

STATUS OUT

CHIP SELECT

SHUT DOWN

* Optional filter capacitor is helpful in a noisy pc board application.

Figure 1. Operating Circuit

FEATURES

The SP8542 and SP8544 are two and four

channel 12-Bit serial In/Out data acquisition

system. The device contains a high speed 12-bit

analog to digital converter, internal reference,

and a two or four channel input Mux which

drives the internal sample and hold circuit.

The SP8542 and SP8544 are fabricated in Sipex'

Bipolar Enhanced CMOS Process that permits

state-of-the-art design using bipolar devices in

the analog/linear section and extremely low

power CMOS in digital/logic section.

CIRCUIT OPERATION

Figure 1 and 2 shows a simple circuit required to

operate the SP8542 and SP8544. Please refer to

the free running mode timing diagram or the

slave mode timing diagram. The conversion is

controlled by the user supplied signals Chip

Select Bar (CS) which selects and deselects the

device, and a system clock (SCLK).

A high level applied to CS asynchronously

clears the internal logic, puts the sample & hold

(CDAC) into sample mode and places the DOUT

(Data Output) pin in a high impedance state.

Conversion is initiated by falling edge on CS in

slave mode at which point the selected input

voltage is held and a conversion is started. A

delay tCS of 90ns is required between the falling

edge of CS and the first rising of SCLK.

The device responds to the shut down signal

asynchronously so that a conversion in progress

will be interrupted and the resulting data will be

erroneous. A 20 µSec delay is required between

the falling edge of shutdown and initiation of

a conversion.

Input Data Format

The SP8542 requires, in addition to the Chip

Select Bar (CS) and System Clock (SCLK)

signals, one multiplexer configuration bit

(MA0). The SP8544 requires, in addition to the

Chip Select Bar (CS) and System Clock (SCLK)

signals, two multiplexer configuration bits (MA1

and MA0). These bits are shifted into the DIN

pin, MSB first, during the first two clocks of the

16 clock conversion cycle and configure the

input multiplexer to select the desired input

channel.

SP8542/8544DS/01

SP8542/8544 Two and Four Channel 12-Bit Multiplexed Sampling ADC's

6

© Copyright 2000 Sipex Corporation

Share Link: