PCD5094H View Datasheet(PDF) - Philips Electronics

Part Name

Description

MFG CO.

PCD5094H

DECT baseband controller

Philips Electronics 

Philips Semiconductors

DECT baseband controller

Objective specification

PCD5094

1 FEATURES

• 80C51 ports P0, P1, P2 and P3 available for interfacing

to display, keyboard, I2C-bus, interrupt sources and/or

external memory. External program memory is

addressable up to 128 kbytes

• +2.7 to 5 V port (P0 to P3) interface

• TDMA frame (de)multiplexing. Transmission or

reception can be programmed for any slot

• Ciphering, scrambling, CRC checking/generation and

protected B-fields

• Speech and data buffering space for six handsets

• Local call and B-field loop-back

• Two interrupt lines for BML and DSP to interrupt 80C51

• On-chip, three-channel time-multiplexed 8-bit

Analog-to-Digital Converter (ADC) for RSSI

measurement, one for battery voltage measurement

and one channel available for other purposes

• On-chip 8-bit Digital-to-Analog Converter (DAC) for

electronic potentiometer function

• Phase error measurement and phase error correction by

hardware

• DACs and ADCs for dynamic earpiece and dynamic or

electret microphone

• On-chip reference voltage

• On-chip supply for electret microphone

• Very low ohmic buzzer output

• Serial interface to external ADPCM CODEC (PCD5032)

or 8 kHz u-law samples

• Speech switch for Digital Telephone Answering

Machine (DTAM) connected to SPI interface

• IOM-2 interface (Siemens registered trademark)

• Serial interface to synthesizer for frequency

programming

• Programmable polarity and timing of radio-control

signals

• GMSK pulse shaper

• On-chip comparator for use as data-slicer

• Easy interfacing with radio circuits, operating at other

supply voltage (RF supply pin with level shifter for RF

signals)

• QFP100 package

• Power-on-reset

• Low power oscillator with integrated frequency

adjustment

• Low supply voltage (2.7 to 3.6 V)

• CMOS technology.

1.1 DSP software features

• ADPCM encoding and decoding complying with G.721

• u-law encoding and decoding complying with G.711

• Echo cancellation and network echo suppressor

• Speech filters

• Programmable gain in speech paths

• Side tone and soft mute

• Ringer and tone (DTMF) generator

• Automatic gain control

• Telephone Answering Machine (TAM) switch

• TAM switch volume control

• Conference between a/b line and two handsets.

For each DSP software version a separate manual is

available in which detailed information is provided on how

parameters must be set. For further information please

contact Philips Semiconductors.

2 GENERAL DESCRIPTION

The PCD5094 is designed for GAP-compliant

basestations offering conference call between the a/b line

and two handsets and answering machine switch. It has an

embedded 80C51 microcontroller with twice the

performance of the classic architecture, 64 kbytes of

PROM program memory and 3 kbytes of data memory on

chip. In addition there is 1 kbyte of on-chip data memory

that is shared with on-chip Burst Mode Logic (BML) and

DSP, the System Data RAM (SDR).

3 ORDERING INFORMATION

TYPE

NUMBER

PCD5094H

NAME

QFP100

PACKAGE

DESCRIPTION

plastic quad flat package; 100 leads (lead length 1.95 mm);

body 14 × 20 × 2.8 mm

VERSION

SOT317-2

1997 Jul 21

3

Share Link: