AD7896AN View Datasheet(PDF) - Analog Devices

Part Name

Description

MFG CO.

AD7896AN

2.7 V to 5.5 V, 12-Bit, 8 μ
s ADC in 8-Lead SOIC/PDIP

Analog Devices 

PIN CONFIGURATION

VIN 1

8 BUSY

VDD 2

AD7896

TOP VIEW

7 CONVST

AGND 3 (Not to Scale) 6 DGND

SCLK 4

5 SDATA

AD7896

Pin No.

1

2

3

4

Mnemonic

VIN

VDD

AGND

SCLK

5

SDATA

6

DGND

7

CONVST

8

BUSY

PIN FUNCTION DESCRIPTIONS

Description

Analog Input. The analog input range is 0 V to VDD.

Positive supply voltage, 2.7 V to 5.5 V.

Analog Ground. Ground reference for track-and-hold, comparator, and DAC.

Serial Clock Input. An external serial clock is applied to this input to obtain serial data from the AD7896.

A new serial data bit is clocked out on the falling edge of this serial clock. Data is guaranteed valid for

10 ns after this falling edge so data can be accepted on the falling edge when a fast serial clock is used.

The serial clock input should be taken low at the end of the serial data transmission.

Serial Data Output. Serial data from the AD7896 is provided at this output. The serial data is clocked

out by the falling edge of SCLK, but the data can also be read on the falling edge of the SCLK. This is

possible because data bit N is valid for a specified time after the falling edge of the SCLK (data hold

time) and can be read before data bit N+1 becomes valid a specified time after the falling edge of SCLK

(data access time) (see Figure 4). Sixteen bits of serial data are provided with four leading zeros followed

by the 12 bits of conversion data. On the 16th falling edge of SCLK, the SDATA line is held for the data

hold time and then disabled (three-stated). Output data coding is straight binary.

Digital Ground. Ground reference for digital circuitry.

Convert Start. Edge-triggered logic input. On the falling edge of this input, the track-and-hold goes into

its hold mode and conversion is initiated. If CONVST is low at the end of conversion, the part goes into

power-down mode. In this case, the rising edge of CONVST “wakes up” the part.

The BUSY pin is used to indicate when the part is doing a conversion. The BUSY pin goes high on the

falling edge of CONVST and returns low when the conversion is complete.

Rev. D

–5–

Share Link: