WM8501 View Datasheet(PDF) - Wolfson Microelectronics plc
Part Name
Description
MFG CO.
WM8501 Datasheet PDF : 21 Pages
| |||
WM8501
Production Data
1/f
LRCLK
Max 4 BCLK's
BCLK
DIN
LEFT CHANNEL
RIGHT CHANNEL
12
MSB
11
12
LSB
Input Word Length (16 bits)
1 16
NO VALID DATA
1
Figure 6 DSP Mode B Timing
AUDIO DATA SAMPLING RATES
The master clock for WM8501 supports audio sampling rates from 128fs to 768fs, where fs is the
audio sampling frequency (LRCLK) typically 32kHz, 44.1kHz, 48kHz, 96kHz or 192kHz. The
master clock is used to operate the digital filters and the noise shaping circuits.
The WM8501 has a master clock detection circuit that automatically determines the relation
between the master clock frequency and the sampling rate (to within +/- 8 master clocks). If there
is a greater than 8 clocks error, the interface shuts down the DAC and mutes the output. The
master clock should be synchronised with LRCLK, although the WM8501 is tolerant of phase
differences or jitter on this clock.
SAMPLING
RATE
(LRCLK)
128fs
MASTER CLOCK FREQUENCY (MHz) (MCLK)
192fs
256fs
384fs
512fs
32kHz
4.096
6.144
8.192
12.288
16.384
44.1kHz
5.6448
8.467
11.2896
16.9344
22.5792
48kHz
6.144
9.216
12.288
18.432
24.576
96kHz
12.288
18.432
24.576
36.864 Unavailable
192kHz
24.576
36.864 Unavailable Unavailable Unavailable
Table 1 Master Clock Frequencies Versus Sampling Rate
768fs
24.576
33.8688
36.864
Unavailable
Unavailable
HARDWARE CONTROL MODES
The WM8501 is hardware programmable providing the user with options to select input audio data
format, de-emphasis and mute.
ENABLE OPERATION
Pin 4 (ENABLE) controls the operation of the chip. If ENABLE is low the device is held in a low
power state. If this pin is held high the device is powered up.
To ensure correct operation it is essential that there is a low to high transition on the ENABLE pin
after digital supplies have come on. This can be achieved by providing the ENABLE signal from
an external controller chip or by means of a simple RC network on the ENABLE pin. See
“Recommended External Components” in the “Application Information” section at the end of this
datasheet.
Note that the ENABLE pin should not be used as a mute pin or to temporarily silence the DAC
(between tracks of a CD for example). The ENABLE pin is not intended to be used as a mute
control but to allow entry into low power mode. Disabling the device via the ENABLE pin has the
effect of powering down the voltage on the VMID pin. Repeated enabling/disabling of the device
can cause audible pops at the output.
w
PD, Rev 4.3, February 2013
12
Share Link: 