TB2104F
Explanation Of Operation
1. Serial data receiver circuit
· The serial data receiver circuit can be changed over to operate in the serial mode or the T-BUS mode by
switching, the AD1 / AD2 terminals.
· In T-BUS mode, the AD1 / AD2 terminals become the chip select code inputs and it becomes possible to
connect up to 8 drivers on the same bus line.
1) Input data format in serial data mode (AD1 = AD2 = “open”)
· Display data are updated when data for 20 bits are input from MSB side (HVO-20), synchronizing
with rise of CLK signal and LS input is set to “H” level after inputting data.
· When increasing driver ICs, connect them through cascade connection as shown below:
2. Input data format in T-BUS mode
3
2002-10-30