LIS331DL(2007) View Datasheet(PDF) - STMicroelectronics

Part Name

Description

View to exact match

LIS331DL
(Rev.:2007)

MEMS motion sensor 3-axis - ±2g/±8g smart digital output “nano” accelerometer

STMicroelectronics 

LIS331DL

Register description

7.13 FF_WU_DURATION_1 (33h)

Table 30. FF_WU_DURATION_1 register

D7

D6

D5

D4

D3

D2

D1

D0

Table 31. FF_WU_DURATION_1 description

D7-D0

Duration value. Default value: 0000 0000

Duration register for Free-Fall/Wake-Up interrupt 1. Duration step and maximum value

depend on the ODR chosen. Step 2.5 msec, from 0 to 637.5 msec if ODR=400Hz, else step

10 msec, from 0 to 2.55 sec when ODR=100Hz. The counter used to implement duration

function is blocked when LIR=1 in configuration register and the interrupt event is verified

7.14

FF_WU_CFG_2 (34h)

Table 32. FF_WU_CFG_2 register

AOI

LIR

ZHIE

ZLIE

YHIE

YLIE

XHIE

XLIE

Table 33.

AOI

LIR

ZHIE

ZLIE

YHIE

YLIE

XHIE

XLIE

FF_WU_CFG_2 description

And/Or combination of Interrupt events. Default value: 0

(0: OR combination of interrupt events; 1: AND combination of interrupt events)

Latch Interrupt request into FF_WU_SRC_2 reg with the FF_WU_SRC_2 reg cleared

by reading FF_WU_SRC_2 reg. Default value: 0

(0: interrupt request not latched; 1: interrupt request latched)

Enable interrupt generation on Z high event. Default value: 0

(0: disable interrupt request;

1: enable interrupt request on measured accel. value higher than preset threshold)

Enable interrupt generation on Z low event. Default value: 0

(0: disable interrupt request;

1: enable interrupt request on measured accel. value lower than preset threshold)

Enable interrupt generation on Y high event. Default value: 0

(0: disable interrupt request;

1: enable interrupt request on measured accel. value higher than preset threshold)

Enable interrupt generation on Y low event. Default value: 0

(0: disable interrupt request;

1: enable interrupt request on measured accel. value lower than preset threshold)

Enable interrupt generation on X high event. Default value: 0

(0: disable interrupt request;

1: enable interrupt request on measured accel. value higher than preset threshold)

Enable interrupt generation on X low event. Default value: 0

(0: disable interrupt request;

1: enable interrupt request on measured accel. value lower than preset threshold)

31/38

Share Link: