CS5158GDR16 View Datasheet(PDF) - Cherry semiconductor

Part Name

Description

View to exact match

CS5158GDR16

CPU 5-Bit Synchronous Buck Controller

Cherry semiconductor 

Applications Information: continued

nates the switch on time, with off time set by the COFF

capacitor. The V2TM control loop will adjust switch duty

cycle as required to ensure the regulator output voltage

tracks the output of the error amplifier.

The soft start and COMP capacitors will charge to their

final levels, providing a controlled turn on of the regulator

output. Regulator turn on time is determined by the COMP

capacitor charging to its final value. Its voltage is limited

by the soft start COMP clamp and the voltage on the soft

start pin (see Figures 2 and 3).

Trace 1 - Regulator Output Voltage (5V/div.)

Trace 2 - Inductor Switching Node (5V/div.)

Figure 4: CS5158 demonstration board enable startup waveforms.

Trace 1 - Regulator Output Voltage (1V/div.)

Trace 2 - Inductor Switching Node (2V/div.)

Trace 3 - 12V input (VCC1 and VCC2) (5V/div.)

Trace 4 - 5V Input (1V/div.)

Figure 2: CS5158 demonstration board startup in response to increasing

12V and 5V input voltages. Extended off time is followed by normal off

time operation when output voltage achieves regulation to the error

amplifier output.

Normal Operation

During normal operation, switch off time is constant and

set by the COFF capacitor. Switch on time is adjusted by the

V2TM control loop to maintain regulation. This results in

changes in regulator switching frequency, duty cycle, and

output ripple in response to changes in load and line.

Output voltage ripple will be determined by inductor rip-

ple current working into the ESR of the output capacitors

(see Figures 5 and 6).

Ch1 High

2.80V

Trace 1 - Regulator Output Voltage (1V/div.)

Trace 3 - COMP Pin (error amplifier output) (1V/div.)

Trace 4 - Soft Start Pin (2V/div.)

Trace 1 - Regulator Output Voltage (10mV/div.)

Trace 2 - Inductor Switching Node (5V/div.)

Figure 5: Peak-to-peak ripple on VOUT = 2.8V, IOUT = 0.5A (light load).

Figure 3: CS5158 demonstration board startup waveforms.

If the input voltage rises quickly, or the regulator output is

enabled externally, output voltage will increase to the level

set by the error amplifier output more rapidly, usually

within a couple of cycles (see Figure 4).

7

Share Link: