AT27BV020-90JI(2001) View Datasheet(PDF) - Atmel Corporation

Part Name

Description

View to exact match

AT27BV020-90JI
(Rev.:2001)

2-Megabit (256K x 8) Unregulated Battery-Voltage High Speed OTP EPROM

Atmel Corporation 

Atmel’s innovative design techniques provide fast speeds

that rival 5V parts while keeping the low power consump-

tion of a 3V supply. At VCC = 2.7V, any byte can be

accessed in less than 90 ns. With a typical power dissipa-

tion of only 18 mW at 5 MHz and VCC = 3V, the AT27BV020

consumes less than one fifth the power of a standard 5V

EPROM. Standby mode supply current is typically less

than 1 µA at 3V. The AT27BV020 simplifies system design

and stretches battery lifetime even further by eliminating

the need for power supply regulation

The AT27BV020 is available in industry standard JEDEC

approved one-time programmable (OTP) plastic PLCC,

TSOP and VSOP packages, as well as a 42-ball, 1 mm

pitch. All devices feature two-line control (CE, OE) to give

designers the flexibility to prevent bus contention.

The AT27BV020 operating with VCC at 3.0V produces TTL

level outputs that are compatible with standard TTL logic

devices operating at VCC = 5.0V. At VCC = 2.7V, the part is

compatible with JEDEC approved low voltage battery oper-

ation (LVBO) interface specifications. The device is also

capable of standard 5-volt operation making it ideally suited

for dual supply range systems or card products that are

pluggable in both 3-volt and 5-volt hosts.

Atmel's AT27BV020 has additional features to ensure high

quality and efficient production use. The Rapid™ Program-

ming Algorithm reduces the time required to program the

part and guarantees reliable programming. Programming

time is typically only 100 µs/byte. The Integrated Product

Identification Code electronically identifies the device and

manufacturer. This feature is used by industry standard

programming equipment to select the proper programming

algorithms and voltages. The AT27BV020 programs

exactly the same way as a standard 5V AT27C020 and

uses the same programming equipment.

System Considerations

Switching between active and standby conditions via the

Chip Enable pin may produce transient voltage excursions.

Unless accommodated by the system design, these tran-

sients may exceed data sheet limits, resulting in device

nonconformance. At a minimum, a 0.1 µF high frequency,

low inherent inductance, ceramic capacitor should be uti-

lized for each device. This capacitor should be connected

between the VCC and Ground terminals of the device, as

close to the device as possible. Additionally, to stabilize the

supply voltage level on printed circuit boards with large

EPROM arrays, a 4.7 µF bulk electrolytic capacitor should

be utilized, again connected between the VCC and Ground

terminals. This capacitor should be positioned as close as

possible to the point where the power supply is connected

to the array.

Block Diagram

2

AT27BV020

Share Link: