ADN4612 View Datasheet(PDF) - Analog Devices
Part Name
Description
View to exact match
ADN4612 Datasheet PDF : 76 Pages
| |||
Data Sheet
ADN4612
POWER SUPPLY AND THERMAL SPECIFICATIONS
Table 2.
Parameter
Test Conditions/Comments
Min Typ Max Unit
POWER SUPPLY OPERATING RANGE VEE = 0 V
VCC
2.25 2.5 2.75 V
DVCC
1.6 1.8 2.0 V
VCC1P8
VTTI 1
VTTO3
1.6 1.8
1.6 1.8
1.64 2.5
2.0 V
2.752 V
3.6 V
POWER SUPPLY NOISE TOLERANCE
VCC
10 Hz to 6.25 GHz
100
mV p-p
DVCC
10 Hz to 100 MHz
100
mV p-p
VCC1P8
VTTI1
VTTO3
10 Hz to 100 MHz
10 Hz to 6.25 GHz
10 Hz to 6.25 GHz
25
mV p-p
100
mV p-p
100
mV p-p
SUPPLY CURRENT
ICC
VCC = 2.5 V
Default, all outputs disabled
120 140 mA
All outputs and main tap enabled, single driver (D0) enabled
391 430 mA
All outputs and main tap enabled, two drivers (D0, D1) enabled
537 590 mA
All outputs and main tap enabled, three drivers (D0 to D2) enabled
684 760 mA
All outputs and main tap and first post tap (D0 to D3) enabled
829 920 mA
All outputs, precursor, main tap, and first post tap (PC, D0 to D3) enabled
944 1070 mA
ITTO5
VTTO = 2.5 V
Default, all outputs disabled
0 <1 mA
All outputs enabled, 8 mA output current per lane
96 106 mA
All outputs enabled, 16 mA output current per lane
192 206 mA
All outputs enabled, 24 mA output current per lane
287 314 mA
All outputs enabled, 32 mA output current per lane
384 416 mA
ITTI6
0
mA
IDVCC
8 12 mA
IVCC1P8
Default, all outputs disabled
78
mA
All outputs main tap enabled
40 43 mA
THERMAL CHARACTERISTICS
Operating Temperature Range
−40
+85 °C
θJA
Still air; JEDEC 4-layer test board, exposed pad soldered
24.0
°C/W
θJC
Still air; thermal resistance through exposed pad
1.7
°C/W
Maximum Junction Temperature
125 °C
1 VTTI is a generic variable that describes both VTTIE and VTTIW. VTTIE and VTTIW are independent voltages that are not required to equal each other.
2 It is recommended that VTTI ≤ VCC to meet the input compliance.
3 VTTO is a generic variable that describes both VTTON and VTTOS. VTTON and VTTOS are independent voltages that are not required to equal each other.
4 The single-ended absolute voltage level, VOL, must be ≤VCC − 1.2 V when operating VTTO at the minimum boundary of the supply range.
5 ITTO is a generic variable that describes both ITTON and ITTOS. ITTON and ITTOS are independent currents that are not required to equal each other.
6 ITTI is a generic variable that describes both ITTIE and ITTIW. ITTIE and ITTIW are independent currents that are not required to equal each other.
Rev. C | Page 5 of 76
Share Link: 