HNC-2.5S-C-A View Datasheet(PDF) - HIROSE ELECTRIC

Part Name

Description

View to exact match

HNC-2.5S-C-A

2.5mm Pitch Connector for Discrete Wire Connection

HIROSE ELECTRIC 

BPrecautions

1. Recommended Soldering Condition Flow: 250ç for 3 seconds

Manual soldering: 290ç for 2 seconds

2. Cleaning Condition

Refer to Nylon Connector Use Hand book.

3. Connection Condition

Refer to Nylon Connector Use Hand book.

qExtracting Crimping Contact

To extract the crimping contact from the socket housing, observe the following extraction

procedures.

sExtraction Tool Tool Name: DF-C-PO(550-0177-7) can be used.

(1) Extraction Method

As shown below in the figure, slightly pull the cable in the state where the DF1 extraction

tool tip or the 0.5 to 0.7mm board has been inserted in the lance fixed slot, the contact can

be easily removed.

Note: If the lance is pressed excessively, the contact body may be deformed, which could

result in contact failure. Therefore, be careful not to press the lance excessively.

(2) How to Adjust the Lance (Raise)

To re-insert the terminal which is removed from the socket housing, use a sharp edge

blade to raise the lance as shown below in the illustration, and then insert the contact.

Note: Lance regeneration is effective only once.

B145

Share Link: