MT9042 View Datasheet(PDF) - Mitel Networks
Part Name
Description
View to exact match
MT9042 Datasheet PDF : 16 Pages
| |||
MT9042
Preliminary Information
VDD
MCLKo
MCLKi
FP8-GCI
F0o
FP8-STB
C1.5
4 3 2 1 28 27 26
5
25
6
24
7
23
8
22
9
21
10
20
11
19
12 13 14 15 16 17 18
RSEL
MS1
MS2
LOSS1
LOSS2
GTo
GTi
Pin Description
Figure 2 - Pin Connections
Pin # Name
Description
1
VSS Negative Power Supply Voltage. Nominally 0 Volts.
2
TRST TIE Circuit Reset (TTL compatible). When HIGH, the time interval error correction circuit is
alternately establishing the phase difference between the PRI and SEC reference inputs,
depending upon which input is selected as input for PLL synchronization. This information is
used to generate a virtual reference for input to the PLL. When LOW, the time interval error
correction circuit is bypassed.
3
SEC Secondary Reference Input (TTL compatible). This input (either 8 kHz, 1.544 MHz, or
2.048 MHz as controlled by the input frequency selection pins) is used as an alternate
reference source for PLL synchronization.
4
PRI Primary Reference Input (TTL compatible). This input (either 8 kHz, 1.544 MHz, or 2.048
MHz as controlled by the input frequency selection pins) is used as the primary reference
source for PLL synchronization.
5
VDD Positive Supply Voltage. Nominally +5 volts.
6 MCLKo Master Clock Oscillator Output. This is a CMOS buffered output used for driving a 20 MHz
crystal.
7
MCLKi Master Clock Oscillator Input. This is a CMOS input for a 20 MHz crystal or crystal
oscillator. Signals should be DC coupled to this pin.
8 FP8-GCI Frame Pulse Output (CMOS compatible). This is an 8 kHz output framing pulse that
indicates the start of the active GCI-BUS frame. The pulse width is based upon the period of
the 8.192 MHz synchronization clock.
9
F0o Frame Pulse Output (CMOS compatible). This is an 8 kHz output framing pulse that
indicates the start of the active ST-BUS frame. The pulse width is based upon the period of
the 4.096 MHz synchronization clock. This is an active low signal.
10 FP8-STB Frame Pulse Output (CMOS compatible). This is an 8 kHz output framing pulse that
indicates the start of the active ST-BUS frame. The pulse width is based upon the period of
the 8.192 MHz synchronization clock.
11
C1.5 Clock 1.544 MHz (CMOS compatible). This ouput is a 1.544 MHz (T1) output clock locked
to the selected reference input signal.
12
C3 Clock 3.088 MHz (CMOS compatible). This output is a 3.088 MHz output clock locked to
the selected reference input signal.
3-98
Share Link: 